Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0432222 (SEM)
 47,337 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Scanning electron microscope studies demonstrate deficiencies in the surfaces of cavity preparations made with conventional cutting instruments. Better surface preparation can be achieved by using appropriate shaped tungsten rotary instruments, and by sharp hand instruments used with a scraping action. The direction of rotation of the cutting alters the quality of the enamel margin. The SEM image should not be interpreted as the sole criterion of clinical success.
 ...
PMID:Burs, teeth and hand instruments. 36 Oct 29

Reactive oxygen metabolites are potent inflammatory mediators that may be involved in tissue injury in inflammatory bowel disease. To evaluate their role in inflammatory bowel disease, we investigated the effects of lowering the activities of reactive oxygen metabolites in experimental colitis induced by intracolonic administration of acetic acid in rats. Intracolonic administration of 5% acetic acid caused severe inflammation (mean (SEM) inflammatory score was 24.3 (0.7) of a maximum score of 32). Acetic acid at 2.5% produced moderate inflammation (score = 17 (1.4) v 4.0 (0.5) in control rats). This lower dose was used for subsequent experiments. Specific superoxide anion scavenger methoxypolyethylene glycol:superoxide dismutase, and reactive oxygen metabolites scavenger, sulfasalazine, significantly decreased the severity of inflammation (scores: 8 (4.4) and 9.8 (2.2) respectively). The xanthine oxidase inhibitors, tungsten and pterin aldehyde, failed to improve inflammation but another xanthine oxidase inhibitor, allopurinol, a compound with known superoxide anion scavenging effect, did limit the inflammation (10(2)). Inhibition of hydroxyl radical production by deferoxamine or lowering hydroxyl radical values by a scavenger, dimethyl sulfoxide, did not affect the severity of inflammation. These data suggest: (1) that reactive oxygen metabolites play an important role in experimental colitis, (2) that the xanthine oxidase pathway is not a major source of reactive oxygen metabolites in colitis, and (3) that tissue injury in experimental colitis is not caused by generation of hydroxyl radicals.
 ...
PMID:Role of reactive oxygen metabolites in experimental colitis. 186 49

Titanium alloys of 10 wt%-72 wt% Cu, 10 wt%-80 wt% Co and 20 wt%-84 wt% Ni were investigated. Ingots were fabricated in a vacuum/argon tungsten arc furnace. The surfaces of the alloys were examined by optical microscopy and SEM/EDS, and the Knoop hardness values of the alloys were measured. The corrosion resistance of the alloys was determined by a potentiodynamic polarization technique in buffered Ringer's solution. When a threshold composition of 30 wt% alloy was reached, a large decrease in corrosion resistance was found to occur. Knoop hardness measurements showed that similar hardness values of approximately 300 KHN can be obtained in all systems with lower alloy content. These values are similar to those obtained with a commercial dental titanium alloy.
 ...
PMID:Cu-Ti, Co-Ti and Ni-Ti systems: corrosion and microhardness. 221 34

The resolution currently available in both transmission and scanning electron microscopes is theoretically adequate to visualize the organization of the cytoskeleton at the supramolecular and macromolecular levels. However, achieving this resolution in practice requires that the methods used to prepare the specimens both preserve the structures of interest and render them visible for observation in the microscope without obscuring or altering them. In this paper we discuss our own and others efforts to develop methods to overcome several problems associated with preparing whole mounts of cytoskeletons for observation by electron microscopy. These problems include: controlling the degree to which cellular components are extracted; the effects of osmium tetroxide on the cytoskeleton; controlling and recognizing shrinkage and drying artifacts; the choice of a method of visualization; deposition of grain-free ultrathin films of metal; and interpreting the results. The standard procedure which we currently use consists of the following steps: growing cells on carbon-stabilized Formvar-coated gold electron microscope grids; extracting in 0.5% Triton X-100 detergent in a microtubule stabilizing buffer; postfixing in 2.5% glutaraldehyde in stabilizing buffer; freeze-drying; magnetron sputter-coating with 1.5 nm of tungsten; and observation by TEM, SEM, or STEM. Cytoskeletons prepared in this manner contain over 100 polypeptides and are composed of a complex three dimensional meshwork of clean, uniform filaments, the smallest of which are 7 nm in diameter. A structure resembling the microtrabecular lattice is present only if the cells are prefixed with a relatively long bifunctional protein crosslinking reagent prior to extraction with detergent.
 ...
PMID:Problems associated with the preparation of whole mounts of cytoskeletons for high resolution electron microscopy. 269 66

Direct evidence for postganglionic sympathetic nerve activation to blood vessels supplying skeletal muscle was sought by recording from the peroneal nerve of 13 volunteers with a 5-mu tipped tungsten needle. Eight subjects breathed through an anesthesia face mask connected to a semiclosed anesthesia circuit for two consecutive 10-min periods while 25% and 40% nitrous oxide (N2O) was administered sequentially. Five subjects served as controls and breathed equivalent concentrations of nitrogen. Blood pressure and central venous pressure were recorded from radial artery and jugular vein catheters. Forearm blood flow was measured by venous occlusion plethysmography. Peroneal nerve recordings were amplified 100,000-fold and integrated for analysis of burst frequency. N2O did not significantly alter respiratory rate, end-tidal CO2 (mass spectrometry), and diastolic or central venous pressures but did produce small but significant increases in heart rate and systolic pressure compared to time-control (P less than 0.05). In contrast, N2O was associated with progressive, large increases in muscle sympathetic nerve activity (peak % delta = 69 +/- 22 burst/min [X +/- SEM]) and forearm vascular resistance (30 +/- 4%) and a nonsignificant increase in plasma norepinephrine levels. Thus, brief exposure to 25% and 40% N2O produces striking increases in sympathetic outflow to skeletal muscle in humans.
 ...
PMID:Nitrous oxide augments sympathetic outflow: direct evidence from human peroneal nerve recordings. 278 44

In this tutorial we describe our methods for preparing detergent-extracted cytoskeletons for observation by high resolution scanning (SEM) and scanning transmission (STEM) electron microscopy. We both discuss the theoretical background and provide practical procedures for each of the following steps: cell culture on Formvar-coated gold grids; prefixation with aldehydes or protein crosslinking reagents (homobifunctional N-hydroxy-succinimide esters); extraction with Triton X-100 or Brij 58 detergent in microtubule stabilizing buffer; postfixation in formaldehyde and glutaraldehyde; dehydration; critical point and freeze drying; sputter coating with 1-2 nm of platinum or tungsten; and examination by SEM and both normal and inverted contrast STEM. These methods produce cytoskeletal preparations in which filaments as fine as 7 nm are preserved and can be observed by scanning electron microscopy.
 ...
PMID:Preparation of cytoskeletons of cells in culture for high resolution scanning and scanning transmission electron microscopy. 305 82

This paper describes the use of sputter coating to prepare detergent-extracted cytoskeletons for observation by scanning (SEM), scanning transmission (STEM), inverted contrast STEM, and transmission (TEM) electron microscopy. Sputtered coats of 1-2 nm of platinum or tungsten provide both an adequate secondary electron signal for SEM and good contrast for STEM and TEM. At the same time, the grain size of the coating is sufficiently fine to be just at (platinum) or below (tungsten) the limit of resolution for SEM and STEM. In TEM, the granular structure of platinum coats is resolved, and platinum decoration artifacts are observed on the surface of structures. The platinum is deposited as small islands with a periodic distribution that may reveal information about the underlying molecular structure. This method produces samples that are similar in appearance to replicas prepared by low-angle rotary shadowing with platinum and carbon. However, the sputter-coating method is easier to use; more widely available to investigators; and compatible with SEM, STEM, and TEM. It may also be combined with immunogold and other labeling methods. While TEM provides the highest resolution images of sputter-coated cytoskeletons, it also damages the specimens owing to heating in the beam. In SEM and STEM cytoskeletons are stable and the resolution is adequate to resolve individual microfilaments. The best single method for visualizing cytoskeletons is inverted contrast STEM, which images both the metal-coated cytoskeletal structures and electron-dense material within the nucleus and cytoplasm as white against a dark background. STEM and TEM were both suitable for visualizing colloidal gold particles in immunolabeled samples.
 ...
PMID:Use of sputter coating to prepare whole mounts of cytoskeletons for transmission and high-resolution scanning and scanning transmission electron microscopy. 350 40

Gold, platinum and tungsten films were deposited by low energy input (7 mA, 450 V), or high deposition rate (80 mA, 1500 V), diode sputter coating and by ion beam sputter coating. Film structures on Formvar coated grids and on the surface of coated erythrocytes, resin embedded, sectioned, and recorded at high magnification in a TEM were compared using computer-assisted measurements and analysis of film thickness and grain size. The average grain size of the thinnest gold and platinum films was relatively independent of the mode or rate of deposition but as the film thickness increased, significant differences in grain size and film structure were observed. Thick platinum or gold films deposited by low energy input sputter coating contained large grain size and electron transparent cracks; however, more even films with narrower cracks but larger grain size were produced at high deposition rates. Ion beam sputter coated gold had relatively large grain size in 10 nm thick films, but beyond this thickness the grains coalesced to form a continuous film. Platinum films deposited by ion beam sputter coating were even and free of electron transparent cracks and had a very small grain size (1-2 nm), which was relatively independent of the film thickness. Tungsten deposition either by low energy input or ion beam sputter coating resulted in fine grained even films which were free of electron transparent cracks. Such films remained granular in substructure and had a grain size of about 1 nm which was relatively independent of film thickness. Tungsten films produced at high deposition rates were of poorer quality. We conclude that thick diode sputter coated platinum and gold films are best deposited at high deposition rates provided the specimens are not heat sensitive, the improvement in film structure being more significant than the slight increase in grain size. Thick diode or ion beam sputter coated gold films should be suitable for low resolution SEM, and thin discontinuous gold films for medium resolution SEM. Diode sputter coated platinum should be suitable for medium resolution SEM and ion beam sputter coated platinum for medium and some high resolution SEM. 1-5 nm thick tungsten films, deposited by low energy input or ion beam sputter coating should be suitable for high resolution SEM, particularly where contrast is of less importance than resolution.
 ...
PMID:Structure analysis of sputter-coated and ion-beam sputter-coated films: a comparative study. 635 10

The trimming of composite resin restorations encompasses gross finishing, contouring, fine finishing, and polishing. A series of aluminum oxide-coated flexible disks have been marketed and are suitable for that purpose. However, their use is confined to directly accessible convex surfaces. For precise finishing of small delineated areas, and for concave and occlusal surfaces, rigid rotary instruments are necessary. The currently used stones and tungsten carbide burs are ineffective with microfilled composite systems. Thus, a series of finishing burs coated with 40- and 15-microns diamond chips were evaluated because of the superior grinding effectiveness as compared with existing instruments. Surface roughness measurements, and qualitative and quantitative SEM evaluations, indicate that these fine and superfine diamond finishing burs produce surfaces on composite resins as smooth as tungsten carbide burs and stones. At the same time, they cause less surface and subsurface damage or marginal fractures on composite resin restorations. The three-year clinical experience is generally favorable. Further quantitative clinical studies are warranted.
 ...
PMID:New finishing instruments for composite resins. 657 90

Intrafascicular recordings of afferent multi-unit activity were obtained from the supraorbital nerve in 40 healthy human volunteers, using tungsten micro-electrodes inserted percutaneously at the eyebrow. Seventy-seven fascicular receptive fields were mapped; their area ranged from 2 to 76 cm2, with a median of 19 cm2. The smallest fields were found in the eyebrow region, and the largest on the scalp. In response to non-painful electrical intradermal stimulation, the conduction velocity of the fastest nerve fibres was calculated to be 40 +/- 2 m s-1 (mean +/- SEM), and the later part of the afferent volley corresponded to a velocity of 20 +/- 1 m s-1. The responses to skin indentation indicated that the density of mechanoreceptive innervation was higher in the lower part of the forehead than in the upper/posterior part of the innervation territory of the nerve. A rapid mechanical tap on the forehead and scalp evoked two major afferent volleys corresponding to the on- and off-phase of the stimulus. Manipulation of hairs resulted not only in dynamic responses to hair movement, but also in a static discharge during sustained hair displacement. When a fascicular field included the eyebrow region, skin stretching during blinking movements evoked distinct afferent activity. Following mechanical and electrical stimuli there were no signs of 'trigeminal antidromic potentials' of the type described in the cat and monkey.
 ...
PMID:Intrafascicular recordings of afferent multi-unit activity from the human supraorbital nerve. 797 24


1 2 3 4 5 6 7 8 9 10 Next >>