Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0432222 (SEM)
 47,337 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Similar to mercuric chloride, silver nitrate has recently been shown to induce IgG autoantibodies targeting the nucleolar 34-kDa protein fibrillarin i SJL (H-2s) mice. In the present study we show that the autoimmunogenic effect of silver is dependent on intact T-cell function since SJL/N mice homozygous for the nude mutation (athymic), in contrast to the functionally T-cell-intact SJL/N-nu/+ littermates, did not develop anti-nucleolar/anti-fibrillarin autoantibodies (ANoA/AFA). The genetic susceptibility for silver-induced AFA was localized to the H-2A locus using congenic and intra-H-2-recombinant strains. However, background (non-H-2) genetic factors substantially influenced both the response rate and the titer of ANoA/AFA attained. Strains bearing H-2As on the SJL and A backgrounds (SJL, A.SW, A.TH) showed 100% response rate and high ANoA titers (3750 +/- 246, mean reciprocal titer +/- SEM), whereas H-2As mice on the B10 background (B10.S) showed 60% response rate and significantly lower ANoA titers (1170 +/- 305) in the responding mice. Expression of H-2E [B10.S(9R) mice] further reduced the response rate (22%) and the ANoA titer (640 +/- 0). A suppressive effect on the B10 background has previously been observed in mercury treatment, but the effect was stronger in silver-treated mice. Two major differences were noted between silver- and mercury-induced murine autoimmunity. First, silver-treated mice did not show elevated titers of other autoantibody specificities, specifically not of antichromatin and anti-histone antibodies, which develop in mercury-treated SJL mice.(ABSTRACT TRUNCATED AT 250 WORDS)
 ...
PMID:Genetic susceptibility to silver-induced anti-fibrillarin autoantibodies in mice. 758 39

BACKGROUND: It is estimated that over 80% of respirable particulate matter (PM10) in cities comes from road transport and that tire and brake wear are responsible for the 3-7% emission of it. Data on the indicators of environmental impact of tire debris (TD), originated from the tire abrasion on roads, are extremely scarce, even though TD contains chemicals (zinc and organic compounds) which can be released in the environment. METHODS: TD particle morphology was analysed with SEM, TEM and FIB instruments. TD eluates and TD organic extracts were tested at dilution series on human cell lines and Xenopus laevis embryos. 50 and 100 g/L TD were used for the eluates obtained after 24 h at pH 3 and the quantity of zinc present was measured with a ICP-AES. Eluates diluted to 1%, 10%, 50% in culture media and undiluted were used on X. laevis embryos in the FETAX test. HepG2 cells were exposed for 24 h to 0.05 - 50 mug/ml of zinc salt while A549 cells were exposed for 24, 48 and 72 h to 10, 50, 60, or 75 mug/ml of TD extract. X. laevis embryos were exposed to 50, 80, 100, or 120 mug/ml TD extract. RESULTS: The solution of undiluted 50 g/L TD produced 80.2% mortality (p < 0.01) in X. laevis embryos and this toxic effect was three times greater than that produced by 100 g/L TD. Zn accumulation in HepG2 cells was evident after 4 h exposure. A549 cells exposed to TD organic extract for 72 h presented a modified morphology, a decrease in cell proliferation and an increase in DNA damage as shown by comet assay. The dose 80 mug/ml of TD extract produced 14.6% mortality in X. laevis embryos and 15.9% mortality at 120 mug/ml. Treatment with 80, 100, or 120 mug/ml TD organic extract increased from 14.8% to 37.8% malformed larvae percentages compared to 5.6% in the control. CONCLUSION: Since the amount of Zn leached from TD is related to pH, aggregation of particles and elution process, the quantity of TD present in the environment has to be taken into account. Moreover the atmospheric conditions, which may deeply influence the particle properties, have to be considered. The TD organic fraction was toxic for cells and organisms. Thus, because of its chemical components, TD may have a potential environmental impact and has to be further investigated.
 ...
PMID:Impact of tire debris on in vitro and in vivo systems. 1581 62

A novel focused ion beam-based technique is presented for the read-out of microradiographs of Caenorhabditis elegans nematodes generated by soft x-ray contact microscopy (SXCM). In previous studies, the read-out was performed by atomic force microscopy (AFM), but in our work SXCM microradiographs were imaged by scanning ion microscopy (SIM) in a focused ion beam/scanning electron microscope (FIB/SEM). It allows an ad libitum selection of a sample region for gross morphologic to nanometric investigations, with a sequence of imaging and cutting. The FIB/SEM is less sensitive to height variation of the relief, and sectioning makes it possible to analyse the sample further. The SXCM can be coupled to SIM in a more efficient and faster way than to AFM. Scanning ion microscopy is the method of choice for the read-out of microradiographs of small multicellular organisms.
 ...
PMID:Read-out of soft X-ray contact microscopy microradiographs by focused ion beam/scanning electron microscope. 1626 77

Dual beam scanning electron microscope/focused ion beam (SEM/FIB) methods complement electropolishing methods and enable specimens to be made from a wider range of materials. Several methods have been developed to fabricate specimens from different forms of materials, including thin ribbons, mechanically ground sheet and fine powders. In addition, FIB-based methods can be used in conjunction with electropolishing methods to improve the shape, surface finish and taper angle of specimens. Several lift-out (LO) methods have been developed for selecting specific microstructural features or other regions of interest such as phases, interfaces, grain boundaries, subsurface or implanted regions and interdendritic regions. These LO methods make use of an in situ nanomanipulator and platinum deposition to transfer and attach the lifted out volume to a post for final annular milling into a needle-shaped specimen. In order to improve the efficiency and to facilitate the LO procedure, some special specimen mounts that hold both the specimen and the support post at the appropriate working distance have been developed.
 ...
PMID:Atom probe specimen preparation with a dual beam SEM/FIB miller. 1740 81

A dual FIB/SEM provides solutions to many challenges in atom probe specimen preparation. When combined with an in situ lift-out capability, the versatility of this tool allows almost any region of interest, in almost any geometry, to be placed at the apex of a specimen tip. Several preparation techniques have been developed in response to specific application requirements; for example, in cases where materials are not suitable for electropolishing, or where site-specific analysis is required. Two general techniques, with wide-ranging potential applications, are described in detail here. The first is a 'cut-out' technique that provides a relatively quick means of micro-tip specimen preparation from bulk material samples. The second method is a 'lift-out' technique that can be used in an in situ or ex situ mode and does not require the preparation of pre-sharpened mounting points.
 ...
PMID:Atom probe specimen fabrication methods using a dual FIB/SEM. 1748 66

We report the use of a focused ion beam/scanning electron microscope (FIB/SEM) for simultaneous investigation of digestive gland epithelium gross morphology and ultrastructure of multilamellar intracellular structures. Digestive glands of a terrestrial isopod (Porcellio scaber, Isopoda, Crustacea) were examined by FIB/SEM and by transmission electron microscopy (TEM). The results obtained by FIB/SEM and by TEM are comparable and complementary. The FIB/SEM shows the same ultrastructural complexity of multilamellar intracellular structures as indicated by TEM. The term lamellar bodies was used for the multillamellar structures in the digestive glands of P. scaber due to their structural similarity to the lamellar bodies found in vertebrate lungs. Lamellar bodies in digestive glands of different animals vary in their abundance, and number as well as the thickness of concentric lamellae per lamellar body. FIB/SEM revealed a connection between digestive gland gross morphological features and the structure of lamellar bodies. Serial slicing and imaging of cells enables easy identification of the contact between a lamellar body and a lipid droplet. There are frequent reports of multilamellar intracellular structures in different vertebrate as well as invertebrate cells, but laminated cellular structures are still poorly known. The FIB/SEM can significantly contribute to the structural knowledge and is always recommended when a link between gross morphology and ultrastructure is investigated, especially when cells or cellular inclusions have a dynamic nature due to normal, stressed or pathological conditions.
 ...
PMID:Imaging of intracellular spherical lamellar structures and tissue gross morphology by a focused ion beam/scanning electron microscope (FIB/SEM). 1806 3

Carbon fiber composite (CFC) targets are investigated by a focused ion beam/scanning electron microscope (FIB/SEM) in a joint project aiming at the development of robust divertors in the International Thermonuclear Experimental Reactor (ITER). These mockups are exposed to a plasma that simulates the off-normal thermal loads foreseen for ITER and display a rich, puzzling impact scenario. Morphological elements are identified at the exposed surface and beneath it, and are examined in order to point out the relevant processes involved. Each technique adopted is discussed and evaluated.
 ...
PMID:Carbon fiber composite targets for nuclear fusion technology: a focused ion beam/scanning electron microscope investigation. 1820 Jun 78

Surface processing of a Ti-6Al-4V alloy led to a complex multilayered microstructure containing several phases of the Ni-Ti-P-Al-O system, which improves the mechanical and tribological surface properties. The microstructure, chemical and phase compositions of the hard layer formed on the surface were investigated by LM, XRD, SEM as well as analytical/high-resolution TEM, STEM, EDS, electron diffraction and FIB. Phase identification based on electron diffraction, HRTEM and EDS microanalysis revealed the presence of several binary and ternary phases in the system Ti-Ni-P, sometimes with partial substitution of Ti by Al. However some phases, mainly nanoparticles, still remain not identified satisfactorily. Electron microscopy techniques used for identification of phases present in surface multilayers and some practical limits to their routine application are reminded here.
 ...
PMID:Characterisation of phases in nanostructured, multilayered titanium alloys by analytical and high-resolution electron microscopy. 1832 19

The patterns of Ni release from Nitinol vary depending on the type of material (Ni-Ti alloys with low or no processing versus commercial wires or sheets). A thick TiO(2) layer generated on the wire surface during processing is often considered as a reliable barrier against Ni release. The present study of Nitinol wires with surface oxides resulting from production was conducted to identify the sources of Ni release and its distribution in the surface sublayers. The chemistry and topography of the surfaces of Nitinol wires drawn using different techniques were studied with XPS and SEM. The distribution of Ni into surface depth and the surface oxide thickness were evaluated using Auger spectroscopy, TEM with FIB and ELNES. Ni release was estimated using either ICPA or AAS. Potentiodynamic potential polarization of selected wires was performed in as-received state with no strain and in treated strained samples. Wire samples in the as-received state showed low breakdown potentials (200 mV); the improved corrosion resistance of these wires after treatment was not affected by strain. It is shown how processing techniques affect surface topography, chemistry and also Ni release. Nitinol wires with the thickest surface oxide TiO(2) (up to 720 nM) showed the highest Ni release, attributed to the presence of particles of essentially pure Ni whose number and size increased while approaching the interface between the surface and the bulk. The biological implications of high and lasting Ni release are also discussed.
 ...
PMID:The influence of surface oxides on the distribution and release of nickel from Nitinol wires. 1899 86

The study of biological processes has become increasingly reliant on obtaining high-resolution spatial and temporal data through imaging techniques. As researchers demand molecular resolution of cellular events in the context of whole organisms, correlation of non-invasive live-organism imaging with electron microscopy in complex three-dimensional samples becomes critical. The developing blood vessels of vertebrates form a highly complex network which cannot be imaged at high resolution using traditional methods. Here we show that the point of fusion between growing blood vessels of transgenic zebrafish, identified in live confocal microscopy, can subsequently be traced through the structure of the organism using Focused Ion Beam/Scanning Electron Microscopy (FIB/SEM) and Serial Block Face/Scanning Electron Microscopy (SBF/SEM). The resulting data give unprecedented microanatomical detail of the zebrafish and, for the first time, allow visualization of the ultrastructure of a time-limited biological event within the context of a whole organism.
 ...
PMID:Imaging transient blood vessel fusion events in zebrafish by correlative volume electron microscopy. 1989 45


1 2 3 4 5 6 7 8 9 10 Next >>