Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0276640 (TEM)
 20,729 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The effect of biomaterials on the activation of human neutrophils was studied. Human neutrophils were incubated with F-75 cobalt-based alloy or polystyrene microspheres of a nonphagocytosable size with two times total neutrophil plane surface area. Scanning and transmission electron microscope (SEM, TEM), energy dispersive x-ray microanalysis (EDX), and graphite furnace atomic absorption spectroscopy (GFAAS) were used to analyze changes in cellular morphology and metal content. This report presents evidence that human PMNs display morphological changes related to foreign material challenge, including activation on F-75 bead surfaces, pinocytosis of corrosion products, formation of intracellular vacuoles, degranulation, etc. Moreover, when PMNs were present, the corrosion release rate of F-75 increased as much as three times over cell-free controls.
 ...
PMID:Human neutrophil response to short-term exposure to F-75 cobalt-based alloy. 142 68

The TEM-EDS bulk-tissue analysis procedure described involves: (1) low-temperature oxygen-plasma ashing of soft tissue specimens weighing greater than 20 micrograms in aluminum-foil crucibles; (2) the solubilization of the ash in 5 microliter 0.5N HNO3 containing a known quantity of cobalt as an internal, non-interfering reference element; (3) the spraying of the solubilized ash from glass microcapillary tubes onto thin carbon-collodion films mounted on titanium grids; (4) EDS analysis of individual microdroplets approximately 3 micron in diameter; (5) the quantitation of elemental concentrations from the element: cobalt intensity ratio by the "ratio model" technique. This technique was assessed and found to yield linear curves (greater than or equal to 0.999) for elements in 'artificial tissue' standards (concentration range = 5 - 340 mM kg-1 dry weight). The overall reproducibility of the technique is therefore quite good (e.g. error of 4.7% for P and K in 25 analyses) within the range of concentrations expected for most of the major biological elements encountered in vertebrate and invertebrate soft tissues. Absolute accuracy can be improved with quantitative procedures that account for peak-overlapping and escape peak contributions etc., so that the ultimate MDL for sodium may well be of the order of 1 mM kg-1 dry weight. The usefulness of the technique for the provision of basic biochemical information (especially in invertebrate systems which have received but meagre attention) is illustrated: (a) by comparing the calcium content of male and female blood-flukes (Schistosoma mansoni) in mixed-sex and unisexual laboratory infections; and (b) by determining the changes induced by daily injections of the drug Astiban on the element composition of female Schistosoma. We conclude that the technique can represent a useful multi-element detection facility which offers certain pertinent advantages over alternative microchemical techniques, such as atomic absorption spectrophotometry.
 ...
PMID:The electron microprobe analysis of sprayed microdroplets of solubilized biological tissues: a useful preliminary to localization studies. 663 80

A computer-controlled tracking cobalt unit (CCTCU) was commissioned for treating patients in January 1980. The system has proved to be reliable and acceptable in routine use for conventional and conformation therapy. The system comprises a modified TEM MS90 Mobaltron, a Hewlett-Packard System 1000 Model 30 mini-computer and user programmes. Tracking techniques are suitable for the treatment of tumours of the oesophagus, thyroid, bronchus, chains of lymph nodes or medulloblastoma. Tumours 85 cm long can be treated at the isocentre. The high dose volume may be considerably reduced when tracking techniques are used instead of conventional techniques. The major obstacle to the routine use of conformation therapy is treatment planning. Work in progress is designed to produce a computerized planning system linking a CT scanner and the CCTCU. It is expected that the system will produce both a plan optimized in 3-D and the necessary control data in machine readable form within an hour of a patient being scanned. The present planning system is based on a Rad-8 planning system and an Alderson phantom to verify the dose distribution in 3-D. An outline of the tracking technique is given. The computer control system is described briefly, with its methods of use for treating patients. Brief reverence is made to work at other centres using conformation therapy.
 ...
PMID:Conformation therapy at the Royal Free Hospital. A progress report on the tracking cobalt project. 729 32

Colloidal dispersions of poly(N-vinyl-2-pyrrolidone) (PVP)-stabilized ruthenium-platinum and ruthenium-palladium bimetallic colloids were prepared by NaBH4 reduction of the corresponding mixed-metal salts at room temperature and characterized by TEM, XPS, and XRD. The resulting bimetallic colloids were used as catalysts for the selective hydrogenation of o-chloronitrobenzene (o-CNB) in methanol at 303 K under 0.1 MPa of hydrogen. It was observed that the catalytic performance of PVP-stabilized ruthenium-platinum colloids (PVP-Ru/Pt) and ruthenium-palladium colloids (PVP-Ru/Pd) was dependent on their compositions and could be remarkably affected by some added metal cations. In the presence of cobalt ion, nearly 100% selectivity to o-chloroaniline (o-CAN) was achieved over PVP-Ru/Pt colloids at 100% conversion of o-CNB, with an activity two orders of magnitude higher than that of monometallic PVP-Ru colloid. Copyright 1999 Academic Press.
 ...
PMID:Preparation and Characterization of Polymer-Stabilized Ruthenium-Platinum and Ruthenium-Palladium Bimetallic Colloids and Their Catalytic Properties for Hydrogenation of o-Chloronitrobenzene. 1033 63

Mesoporous silica gels modified due to pyrolysis of acetylacetone or acetylacetonates (AcAc) of zirconium [Zr(AcAc)(4)], titanium [titanyl TiO(AcAc)(2)], nickel [Ni(AcAc)(2)], zinc [Zn(AcAc)(2)], chromium [Cr(AcAc)(3)], and cobalt [Co(AcAc)(2)] were studied using nitrogen adsorption-desorption, TPD-DTG, TEM, XRD, and XRF methods. Grafted C/X phases consist of metal compounds (X denotes oxide, silicate, or metal crystallites) and pregraphite pyrocarbon, whose characteristics can be varied by changing the metal in M(AcAc)(n). The structural parameters of C/X/SiO(2), such as the specific surface area of micro- and mesopores, pore volume, pore size and fractal dimension distributions, and adsorptive ability, depend nonlinearly on the concentrations of the C/X deposit due to alterations in the topology of grafted matters with increased concentrations and a possible catalytic effect of the X phase on pyrolysis. Copyright 2000 Academic Press.
 ...
PMID:Silica Gel Modified Due to Pyrolysis of Acetylacetone and Metal (Ti, Cr, Co, Ni, Zn, Zr) Acetylacetonates. 1108 43

Previous studies of the formation of buried silicide layers through mesotaxy, i.e., the introduction of the metal component by ion implantation with subsequent annealing of the structure, have shown that high-quality films can be achieved, but at processing temperatures too high to be useful for integration with silicon device technology. Recently, we proposed a modified ripening model to describe the early stages of the formation of a buried film which intentionally excluded the role of defects. In the current study, the predictions of that model are tested by varying sample preparation conditions. We show that the shift of the silicide precipitate layer is correlated with the narrowing of the cobalt profile, thus requiring both processes to be described by the same mechanism. We also show in a TEM study that specific defect morphologies are correlated with specific properties of the forming buried film, requiring an extension of the previous model.
 ...
PMID:Role of ripening and defects in the formation of mesotaxial cobalt-disilicide layers. 1121 32

Reduction of platinum acetylacetonate and thermodecomposition of cobalt carbonyl in the presence of 1-adamantanecarboxylic acid were employed in different coordinating mixtures to produce monodisperse, highly crystalline CoPt(3) nanoparticles. The mean particle size can be varied from 1.5 to 7.2 nm by controlling the reaction conditions and the type of coordinating mixture. As-synthesized CoPt(3) particles represent single crystal domains and have chemically disordered face-centered cubic (fcc) structure. Nearly spherical CoPt(3) nanocrystals were found to assemble into two- (2D) and three-dimensional (3D) structures. An AB(5) type superlattice is observed by TEM after mixing two nanoparticle samples with different mean sizes. Slow precipitation led to the formation of facetted colloidal crystals with sizes up to 20 microm.
 ...
PMID:Colloidal synthesis and self-assembly of CoPt(3) nanocrystals. 1223 62

Porous nickel and cobalt oxides were prepared using their alkoxides as inorganic precursors. The stabilization of the mesostructure is especially critical for divalent elements such as Ni and Co, which do not form any network structure, like silicates. The lack of a network-forming multivalent bond is the probable reason why no stable mesoporous oxides have been synthesized for divalent elements yet. Here we have reported our attempt to synthesize porous oxides of Ni and Co. Octadecylamine has been used as the organic structure-directing agent. The product obtained was put under solvent extraction and calcination at various temperatures to remove the surfactant, followed by characterization using XRD, TEM and BET measurements. The FT/IR and thermal analyses (TGA and DSC) were also carried out for supporting information, such as extent of removal of surfactant from the pores of the metal oxide. A relatively better surface area has been obtained for the Co oxide, but in Ni the surface area found is not as good. A possible reason for that has been discussed. The porous (solvent extracted) cobalt oxide has been used as a catalyst in the oxidation reaction of cyclohexane in mild conditions. The catalyst has shown relatively better conversion of cyclohexane into cyclohexanone and cyclohexanol than the nanostructured cobalt oxide catalyst of regular structure.
 ...
PMID:Preparation of porous cobalt and nickel oxides from corresponding alkoxides using a sonochemical technique and its application as a catalyst in the oxidation of hydrocarbons. 1245 44

Near-edge fine structures of the metal L(2,3) and O K-edges in transition metal-oxides have been studied with a transmission electron microscope equipped with a monochromator and a high-resolution imaging filter. This system enables the recording of EELS spectra with an energy resolution of 0.1eV thus providing new near-edge fine structure details which could not be observed previously by EELS in conventional TEM instruments. EELS-spectra from well-defined oxides like titanium oxide (TiO(2)), vanadium oxide (V(2)O(5)), chromium oxide (Cr(2)O(3)), iron oxide (Fe(2)O(3)), cobalt oxide (CoO) and nickel oxide (NiO) have been measured with the new system. These spectra are compared with EELS data obtained from a conventional microscope and the main spectral features are interpreted. Additionally, the use of monochromised TEMs is discussed in view of the natural line widths of K and L(2,3) edges.
 ...
PMID:Electron energy-loss near-edge structures of 3d transition metal oxides recorded at high-energy resolution. 1287 9

Co and NiFe nanoparticles (2.7 to 3.3 nm mean diameter) of narrow size distribution have been obtained through the decomposition of organometallic precursors in organic solutions of long alkyl chain ligands, namely oleic acid and hexadecylamine. Materials of various volume fractions were produced. The particles have been structurally characterised by WAXS. Both adopt the bulk structure: HCP in the case of cobalt; a mixture of FCC and BCC for NiFe. Their aptitude to self-assemble either on flat supports or in bulk solid state has been investigated by means of TEM and SAXS. This study suggests the crystallisation of the nanoparticles upon solvent evaporation, especially a local FCC arrangement was observed for the NiFe material. Magnetic measurements (SQUID) confirm this tendency. The blocking temperature depends on the metal volume fraction, i.e. on the anisotropy generated by the dipolar couplings (Ki). We show that, for dense samples, the particles of high intrinsic anisotropy, Ku, (Co) still display an individual behaviour while the soft ones (NiFe) display a collective behaviour.
 ...
PMID:Magnetic nanoparticles through organometallic synthesis: evolution of the magnetic properties from isolated nanoparticles to organised nanostructures. 1475 Jun 76


1 2 3 4 5 6 7 8 9 10 Next >>