Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0267964 (PAA)
 2,561 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Two weak poly(acid)s, poly(acrylic acid) (PAA) and poly(N-acryloyl-glycine) (P1), were graft-copolymerized onto porous cellulose membrane and their protonation behavior in aqueous media was studied by potentiometric techniques. Comparison with the corresponding free polymers in solution showed the same basicity constants during the protonation of ionized carboxyl groups, and the large potentiometric hysteresis loops observed for the grafts were indicative of specific interactions with the cellulose substrate. This was confirmed by FT-IR spectroscopic analysis at low pH. The polymeric membrane system, containing immobilized glucose oxidase, was synthesized for the purpose of insulin delivery in response to glucose concentration. The porosity of the membrane was controlled by the charge-state conformations of the grafted chains. The formation of gluconic acid in the presence of glucose caused a drop in pH which led to neutralization of the negatively charged carboxyl groups. The decrease in electrostatic repulsion caused the extended macromolecular chain to assume a coil-like form and opened the membrane pores to insulin.
 ...
PMID:An insulin-releasing system responsive to glucose: thermodynamic evaluation of permeability properties. 175 61

In this paper we show that hyperbranched polymers can be used as a host matrix for electrostatic entrapment of enzymes. Specifically, amine-functionalized glucose oxidase (GOx+) and horseradish peroxidase, as well as poly(amidoamine) dendrimer-modified horseradish peroxidase, reversibly sorb into polyanionic, hyperbranched poly(sodium acrylate) (PAA-) films that are on the order of a few hundred angstroms thick. The quantity of GOx+ entrapped within the PAA- films depends on the nature of film preparation but is typically on the order of 0.06 unit/cm2. The extent to which entrapped GOx+ retains its activity depends on the film history, but for PAA-/GOx+ composites not exposed to glucose and stored at 4 degrees C, the original activity is retained for up to 68 days and perhaps longer.
 ...
PMID:Electrostatic immobilization of glucose oxidase in a weak acid, polyelectrolyte hyperbranched ultrathin film on gold: fabrication, characterization, and enzymatic activity. 1045 Jan 59

Layer-by-layer supramolecular structures composed of alternate layers of negatively charged enzymes and cationic redox polyelectrolyte have been assembled. Glucose oxidase (GOx), lactate oxidase (LOx) and soybean peroxidase (SBP) have been electrically wired to the underlying electrode by means of poly(allylamine) with [Os(bpy)2ClPyCOH]+ covalently attached (PAA-Os) in organized structures with high spatial resolution. Biotinylated glucose oxidase has also been used to assemble step-by-step on antibiotin goat immunoglobulin (IgG) layers and the enzyme was electrically wired by PAA-Os. These spatially organized multilayers with mono- and bienzymatic schemes can work efficiently in molecular recognition, redox mediation and generation of an electrical signal. The concentration of redox mediator integrated into the multilayers, obtained from the voltammetric charge and an estimation of the layer thickness, exceeds by 100-fold the amount of deposited enzyme assessed by quartz crystal microbalance. Differences in GOx electrical wiring efficiency have been detected with the different assembling strategies. The surface concentration of electrically wired enzyme represents a small proportion of all the enzyme molecules present in the multilayers which can be oxidized by the soluble mediator [Os(bpy)2Cl PyCOOH]Cl. This proportion, as well as the rate of FADH2 oxidation by PAA-Os, increases with the number of electrically wired enzyme layers and with the spatial accessibility of the Os moiety to the enzyme active center.
 ...
PMID:Layer-by-layer electrostatic deposition of biomolecules on surfaces for molecular recognition, redox mediation and signal generation. 1119 90

The uptake of glucose oxidase (GOx) onto a polycationic redox polymer (PAA-Os)-modified surface, by adsorption from dilute aqueous GOx solutions, was followed by the quartz crystal microbalance (QCM) and shows double exponential kinetics. The electrochemistry of the layer-by-layer-deposited redox-active polymer was followed by cyclic voltammetry in glucose-free solutions, and the enzyme catalysis mediated by the redox polymer was studied in beta-D-glucose-containing solutions. AFM studies of the different layers showed the existence of large two dimension enzyme aggregates on the osmium polymer for 1 microM GOx and less aggregation for 50 nM GOx solutions. When the short alkanethiol, 2,2'-diaminoethyldisulfide was preadsorbed onto gold, a monoexponential adsorption law was observed, and single GOx enzyme molecules could be seen on the surface where the enzyme was adsorbed from 50 nM GOx in water.
 ...
PMID:Layer-by-layer self-assembly of glucose oxidase and Os(Bpy)2CIPyCH2NH-poly(allylamine) bioelectrode. 1130 46

We report the amperometric detection of glucose at 2 fM concentration in a physiological buffer solution at 1 atm O2 pressure. The sensitive assay is based on the close to absolute electroreductive stripping of O2 from the solution near the glucose electrooxidizing anode. The glucose was detected by its electrooxidation on a stationary glassy carbon disk surrounded by an also stationary platinum ring. The disk was coated with a film of glucose oxidase (GOx), electrically "wired" with PVP-[Os(N,N'-dimethyl-2,2'-biimidazole)3]2+/3+ (polymer I), having a redox potential of -0.19 V versus Ag/AgCl. The ring was coated with bilirubin oxidase (BOD) "wired" with PAA-PVI-[Os(4,4'-dichloro-2,2'-bipyridine)2Cl]+/2+ (polymer II), having a redox potential of + 0.36 V versus Ag/AgCl. The ring-disk electrode was held facing up, and a 30-microL drop was placed on it for the assay, with the ring poised at -0.3 V/ AgAgCl and the disk poised at -0.1 V/ Ag/AgCl. Even though the atmosphere over the drop was O2 at 1 atm pressure, the wired BOD disk scavenged the O2 so effectively that the glucose-reduced FADH2 of GOx was not oxidized by O2, the natural cosubstrate of the enzyme.
 ...
PMID:Detection of glucose at 2 fM concentration. 1564 80

In an effort to improve the stability for long-term biosensor use, layer-by-layer self-assembly was explored as a potential technique to provide a diffusion barrier to encapsulated glucose oxidase inside alginate microspheres (<5 microm), fabricated using an emulsification technique. The total loss of encapsulated enzyme was reduced to less than 25 and 15% with the application of single PAH/PSS and crosslinked PAH/PAA coatings, respectively, in comparison to at least a 45% loss observed with uncoated and PDDA/PSS-coated microspheres. Furthermore, it was found that enzyme within PAH/PSS- and crosslinked PAH/PAA-coated spheres retained more than 84 and 60% of initial activity, respectively, after three months, whereas uncoated and PDDA/PSS-coated microspheres retained less than 20%.
 ...
PMID:Stable encapsulation of active enzyme by application of multilayer nanofilm coatings to alginate microspheres. 1609 91

A new strategy for fabricating glucose biosensor was presented by layer-by-layer assembled chitosan (CS)/gold nanoparticles (GNp)/glucose oxidase (GOD) multilayer films modified Pt electrode. First, a cleaned Pt electrode was immersed in poly(allylamine) (PAA), and then transferred to GNp, followed by the adsorption of GOD (GOD/GNp/PAA/Pt). Second, the GOD/GNp/PAA/Pt electrode was immersed in CS, and then transferred to GNp, followed by the adsorption of GOD (GOD/GNp/CS/GOD/GNp/PAA/Pt). Third, different layers of multilayer films modified Pt electrodes were assembled by repeating the second process. Film assembling and characterization were studied by quart crystal microbalance, and properties of the resulting glucose biosensors were measured by electrochemical measurements. The results confirmed that the assembling process of multilayer films was simple to operate, the immobilized GOD displayed an excellent catalytic property to glucose, and GNp in the biosensing interface efficiently improved the electron transfer between analyte and electrode surface. The amperometric response of the biosensors uniformly increased from one to six layers of multilayer films, and then reached saturation after the seven layers. Among the resulting biosensors, the biosensor based on the six layers of multilayer films was best. It showed a wide linear range of 0.5-16 mM, with a detection limit of 7.0 microM estimated at a signal-to-noise ratio of 3, fast response time (within 8s). Moreover, it exhibited good reproducibility, long-term stability and interference free. This method can be used for constructing other thin films, which is a universal immobilization method for biosensor fabrication.
 ...
PMID:Amperometric glucose biosensor based on layer-by-layer assembly of multilayer films composed of chitosan, gold nanoparticles and glucose oxidase modified Pt electrode. 1667 15

A novel amperometric glucose biosensor based on the nine layers of multilayer films composed of multi-wall carbon nanotubes (MWCNTs), gold nanoparticles (GNp) and glucose oxidase (GOD) was developed for the specific detection of glucose. MWCNTs were chemically modified with the H(2)SO(4)-HNO(3) pretreatment to introduce carboxyl groups which were used to interact with the amino groups of poly(allylamine) (PAA) and cysteamine via 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide/N-hydroxysuccinimide cross-linking reaction, respectively. A cleaned Pt electrode was immersed in PAA, MWCNTs, cysteamine and GNp, respectively, followed by the adsorption of GOD, assembling the one layer of multilayer films on the surface of Pt electrode (GOD/GNp/MWCNTs/Pt electrode). Repeating the above process could assemble different layers of multilayer films on the Pt electrode. PBS washing was applied at the end of each assembly deposition for dissociating the weak adsorption. Film assembling and characterization were studied by transmission electron microscopy and quartz crystal microbalance, and properties of the resulting glucose biosensors were measured by electrochemical measurements. The marked electrocatalytic activity of Pt electrode based on multilayer films toward H(2)O(2) produced during GOD enzymatic reactions with glucose permitted effective low-potential amperometric measurement of glucose. Taking the sensitivity and selectivity into consideration, the applied potential of 0.35 V versus Ag/AgCl was chosen for the oxidation detection of H(2)O(2) in this work. Among the resulting glucose biosensors, the biosensor based on nine layers of multilayer films was best. It showed a wide linear range of 0.1-10mM glucose, with a remarkable sensitivity of 2.527 microA/mM, a detection limit of 6.7 microM estimated at a signal-to-noise ratio of 3 and fast response time (within 7s). Moreover, it exhibited good reproducibility, long-term stability and the negligible interferences of ascorbic acid, uric acid and acetaminophen. The study can provide a feasible approach on developing new kinds of oxidase-based amperometric biosensors, and can be used as an illustration for constructing various hybrid structures.
 ...
PMID:Amperometric glucose biosensor based on multilayer films via layer-by-layer self-assembly of multi-wall carbon nanotubes, gold nanoparticles and glucose oxidase on the Pt electrode. 1721 83

Liquid cell atomic force microscopy (LC-AFM) is used to image self-assembled polyelectrolyte films eliminating any drying effects on the film structure. Weak/weak and strong/weak polyelectrolyte films are formed by the alternated deposition of poly(acrylic acid) [PAA]/poly(allylamine hydrochloride) [PAH], and poly(sodium 4-styrene sulfonate) [PSS]/PAH, respectively, forming a granular surface structure. Number and area of grains (GN, GA) are used to characterize the surface of these films during their build up process. We show that hydrophilic PAA increases GA and decreases GN, while these parameters follow an opposite behavior with PSS. In both cases, GA and GN always have a simple inverse relationship, and then grain surface coverage (GS=GNGA) is nearly constant and independent of polyelectrolyte nature and the substrates used here, but also in the published data as well. The drying of the weak/weak film was also imaged after natural and forced solvent evaporation, and the surface structure is strongly affected, although the GS values keep roughly the same value found for wet films. The set of these results indicates that GS may be considered as a constant parameter during the build-up for the self-nascent assembled polyelectrolytes. The granular structure is still maintained after glucose oxidase adsorption on these films with comparable GS values.
 ...
PMID:Granular structure of self-assembled PAA/PAH and PSS/PAH nascent films imaged in situ by LC-AFM. 1844 87

The prevention of nonspecific protein adsorption is a crucial prerequisite for many biomedical and biotechnological applications. Therefore, the design of robust and versatile methods conferring optimal protein-resistance properties to surfaces has become a challenging issue. Here we report the unexpected case of polycation-ending polyelectrolyte multilayers (PEM) that efficiently prevented the adsorption of a negatively charged model protein, glucose oxidase (GOX). PEM films were based on two typical weak poyelectrolytes: poly(allylamine hydrochloride) (PAH) and poly(acrylic acid) (PAA). No chemical modification of the polyelectrolytes was required and tunable GOX adsorption was possible by simply changing the buildup pH conditions. Protein-resistance properties are attributed to high film hydration becoming the predominant factor over electrostatic interactions. We explain this effect by oscillations of the internal PAA ionization state throughout the buildup, which results in an excess of carboxylic acid groups within the film. This excess acts as a reservoir of potential carboxylate groups compensating the outer PAH positive charges. Partial results indicated that the system was also resistant to the adsorption of a positively charged protein, lysozyme. Control of the internal ionization of weak polyelectrolyte multilayers might open a route toward simple tuning of protein adsorption. These results should help to rationalize the design of biomaterials, biosensors, or protein separation devices.
 ...
PMID:Tunable protein-resistance of polycation-terminated polyelectrolyte multilayers. 1961 7


1 2 3 Next >>