Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0231807 (exertional dyspnea)
 3,402 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Site characterization is an essential initial step in determining the feasibility of remedial alternatives at hazardous waste sites. Physicochemical and mineralogical characterization of U-contaminated soils in deeply weathered saprolite at Area 2 of the DOE Field Research Center (FRC) site, Oak Ridge, TN, was accomplished to examine the feasibility of bioremediation. Concentrations of U in soil-saprolite (up to 291 mg kg(-1) in oxalate-extractable U(o)) were closely related to low pH (ca. 4-5), high effective cation exchange capacity without Ca (64.7-83.2 cmol(c) kg(-1)), amorphous Mn content (up to 9910 mg kg(-1)), and the decreased presence of relative clay mineral contents in the bulk samples (i.e., illite 2.5-12 wt. %, average 32 wt. %). The pH of the fill material ranged from 7.0 to 10.5, whereas the pH of the saprolite ranged from 4.5 to 8. Uranium concentration was highest (about 300 mg kg(-1)) at around 6 m below land surface near the saprolite-fill interface. The pH of ground water at Area 2 tended to be between 6 and 7 with U concentrations of about 0.9 to 1.7 mg L(-1). These site specific characteristics of Area 2, which has lower U and nitrate contamination levels and more neutral ground water pH compared with FRC Areas 1 and 3 (ca. 5.5 and <4, respectively), indicate that with appropriate addition of electron donors and nutrients bioremediation of U by metal reducing microorganisms may be possible.
 ...
PMID:Physicochemical and mineralogical characterization of soil-saprolite cores from a field research site, Tennessee. 1689 44

The U.S. Department of Energy (U.S. DOE) is making significant progress with the cleanup of its legacy radioactively-contaminated facilities and sites left from research and development and production of nuclear materials and weapons. Sites like Rocky Flats, Battelle Columbus Laboratories, Fernald, Mound, Brookhaven National Laboratory, Hanford, and Oak Ridge are faced daily with decisions related to disposition of waste and radioactive material. One key to this success is the disposition of waste arising from cleanup. Most of the generated waste volume has very low levels of radioactive contamination. The waste includes contaminated soil, debris from demolition, or scrap metal and equipment. The cost of disposing of large volumes of waste can be prohibitive, so there is incentive to find innovative ways to disposition wastes. This paper describes the current status of policy development in this area, such as development of a draft programmatic environmental impact statement and monitoring of related rulemaking at the U.S. Nuclear Regulatory Commission. The paper also provides an overview of draft U.S. DOE guidance on control and release of property with residual radioactive material, and site-specific applications of DOE guidance.
 ...
PMID:Low-activity radioactive materials management at the U.S. Department of Energy. 1703 62

U.S. Department of Energy (U.S. DOE) regulates its operations with a system of rules, directives, and guidance under the Atomic Energy Act. U.S. DOE's policy is to conduct its radiological operations in a manner that ensures the health and safety of its employees, contractors, and the public. U.S. DOE uses an annual dose limit of 100 mrem (1 mSv) with an "as low as reasonably achievable" (ALARA) process to achieve radiological protection. The primary directive for radiation protection of the public and the environment is DOE Order 5400.5. It contains requirements for the protection of the public and the environment from routine operations, including controlling and releasing property. Since the publication of Order 5400.5 in 1990, U.S. DOE has issued guidance for meeting requirements under it; Guide G 441.1-xx consolidates this guidance. DOE applies a dose constraint of 25 mrem y (0.25 mSy y(-1)), plus ALARA, for the release of real property, and 1 mrem y(-1), plus ALARA, for release of personal property. Models and guidance to develop the needed documentation for release of property are easily available and user-friendly. While achieving protection of human health and the environment, U.S. DOE's dose-based release process has resulted in significant cost savings. U.S. DOE has recently adopted a management systems approach for general environmental and public protection programs. The integration of the radiation protection program into this new approach is a high priority.
 ...
PMID:U.S. Department of Energy policies, directives, and guidance for radiological control and release of property. 1703 68

BMS-353645, also known as sordarin, was of interest based on its activity against pathogenic fungi. The objective of these studies was to provide high quality starting substrate for chemical modification aimed at further improving biological activity, with particular interest in the inhibition of Aspergillus. In the work presented here, Design of Experiments, or DOE, was successfully combined with traditional approaches to significantly improve sordarin yields in fermentation flasks. Overall, yields were increased 25-fold from <100 microg/g to as high as 2,609 microg/g in flasks through the use of various medium and conduction changes supplemented with DOE. The improved process was then successfully scaled to pilot plant tanks with the best batch producing 2,389 microg/g sordarin at the 250-l scale.
 ...
PMID:Improvement of sordarin production through process optimization: combining traditional approaches with DOE. 1713 Nov 4

Identification of the proteins directly involved in microbial metal-reduction is important to understanding the biochemistry involved in heavy metal-reduction/immobilization and the ultimate cleanup of DOE contaminated sites. Although previous strategies for the identification of these proteins have traditionally required laborious protein purification/characterization of metal-reducing capability, activity is often lost before the final purification step, thus creating a significant knowledge gap. In the current study, subcellular fractions of Shewanella oneidensis MR-1 were enriched for Fe(III)-NTA reducing proteins in a single step using several orthogonal column matrices. The protein content of eluted fractions that demonstrated activity was determined by ultra-high pressure liquid chromatography coupled with tandem mass spectrometry (LC-MS/MS). A comparison of the proteins identified from active fractions in all separations produced 30 proteins that may act as the terminal electron-accepting protein for Fe(III)-reduction. These include MtrA, MtrB, MtrC and OmcA as well as a number of other proteins not previously associated with Fe(III)-reduction. This is the first report of such an approach where the laborious procedures for protein purification are not required for identification of metal-reducing proteins. Such work provides the basis for a similar approach with other cultured organisms as well as analysis of sediment and groundwater samples from biostimulation efforts at contaminated sites.
 ...
PMID:Enrichment of functional redox reactive proteins and identification by mass spectrometry results in several terminal Fe(III)-reducing candidate proteins in Shewanella oneidensis MR-1. 1713 61

Surma River is polluted day by day by human activities, poor structured sewerage and drainage system, discharging industrial and household wastes. The charas (natural channels) are responsible for surface runoff conveyance from its urban catchments to the receiving Surma River. Water samples have been collected from a part of Surma River along different points and analyzed for various water quality parameters during dry and monsoon periods. Effects of industrial wastes, municipal sewage, and agricultural runoff on river water quality have been investigated. The study was conducted within the Chattak to Sunamganj portion of Surma River, which is significant due to the presence of two major industries--a paper mill and a cement factory. The other significant feature is the conveyors that travel from India to Chattak. The river was found to be highly turbid in the monsoon season. But BOD and fecal coliform concentration was found higher in the dry season. The water was found slightly acidic. The mean values of parameters were Conductivity 84-805 micros; DO: dry-5.52 mg/l, monsoon-5.72 mg/l; BOD: dry-1mg/l, monsoon-0.878 mg/l; Total Solid: dry-149.4 mg/l, monsoon-145.7 mg/l. In this study, an effort has been taken to investigate the status of concentration of phosphate (PO(-4)) and ammonia-nitrogen (NH4-N) at four entrance points of Malnichara to the city, Guali chara, Gaviar khal and Bolramer khal. Data has been collected from March-April and September-October of 2004. Concentrations have been measured using UV Spectrophotometer. Although the phosphate concentration has been found within the limit set by DOE for fishing, irrigation and recreational purposes, however ammonia-nitrogen has been found to exceed the limit.
 ...
PMID:Deterioration of water quality of Surma river. 1729 73

Safe handling and storage of nuclear material at U.S. Department of Energy facilities relies on the use of robust containers to prevent container breaches and subsequent worker contamination and uptake. The U.S. Department of Energy has no uniform requirements for packaging and storage of nuclear materials other than those declared excess and packaged to DOE-STD-3013-2000. This report describes a methodology for prioritizing a large inventory of nuclear material containers so that the highest risk containers are repackaged first. The methodology utilizes expert judgment to assign respirable fractions and reactivity factors to accountable levels of nuclear material at Los Alamos National Laboratory. A relative risk factor is assigned to each nuclear material container based on a calculated dose to a worker due to a failed container barrier and a calculated probability of container failure based on material reactivity and container age. This risk-based methodology is being applied at LANL to repackage the highest risk materials first and, thus, accelerate the reduction of risk to nuclear material handlers.
 ...
PMID:Risk ranking of LANL nuclear material storage containers for repackaging prioritization. 1744 Mar 28

An attempt has been made to assess the trace elemental interactions of atmospheric aerosol through Taguchi orthogonal array (OA) experimental design (DOE) approach. Seven toxic trace metals (Cu, Cd, As, Pb, Cr, Co and Ni) along with aerosol mass (PM(10)) at three different concentration levels were considered for this study. The annual mean concentrations of PM(10) and its trace components observed at Tirupati, southern peninsular India, and 50% lower and 50% higher values to the permissible exposure limit (PEL) of each factor in air were considered for level 1, level 2, and level 3 respectively. Interactions between the factors have been estimated by orthogonal array design of experiments with eighteen sets of experimental trial (L18) and varied combinations of factor levels.
 ...
PMID:Assessment of aerosol (PM10) and trace elemental interactions by Taguchi experimental design approach. 1749 Jul 43

Based on results of field testing conducted by the U.S. Department of Energy's National Energy Technology Laboratory (DOE/NETL), this article provides preliminary costs for mercury control via conventional activated carbon injection (ACI), brominated ACI, and conventional ACI coupled with the application of a sorbent enhancement additive (SEA) to coal prior to combustion. The economic analyses are reported on a plant-specific basis in terms of the cost required to achieve low (50%), mid (70%), and high (90%) levels of mercury removal "above and beyond" the baseline mercury removal achieved by existing emission control equipment. In other words, the levels of mercury control are directly attributable to ACI. Mercury control costs via ACI have been amortized on a current dollar basis. Using a 20-year book life, levelized costs for the incremental increase in cost of electricity (COE), expressed in mills per kilowatt-hour (mills/kWh), and the incremental cost of mercury control, expressed in dollars per pound of mercury removed ($/lb Hg removed), have been calculated for each level of ACI mercury control. For this analysis, the increase in COE varied from 0.14 mills/kWh to 3.92 mills/kWh. Meanwhile, the incremental cost of mercury control ranged from $3810/lb Hg removed to $166000/lb Hg removed.
 ...
PMID:DOE/NETL's phase II mercury control technology field testing program: preliminary economic analysis of activated carbon injection. 1759 98

This study evaluated the effects of water exposure on the in vitro microtensile bond strength (muTBS) of etch-and-rinse and self-etching adhesives to human dentin over a 1-year storage period. Five adhesive systems used were as follows: a one-step self-etching adhesive (One-up Bond F-OB), two two-step self-etching primers (Clearfil SE Bond-SE and Clearfil Protect Bond-CP), and two etch-and-rinse adhesives (Single Bond-SB and Prime&Bond NT-PB). Dentin surfaces were bonded, restored, and assigned to four subgroups, according to the degree of water exposure: 24 h of peripheral water exposure (24 h-PE) (having circumferential enamel); and 1 year of peripheral exposure (1 yr-PE), direct exposure (1 yr-DE) (dentin directly water-exposed), or directly exposed to oil only (no water exposure) (1 yr-DOE). A composite-enamel bond adjacent to the restoration is determined if the water exposure was peripheral or direct. After storage periods, specimens were serially sectioned, trimmed to an hourglass shape with a cross-sectional area of 1 mm(2) at the interface, and tested in tension. Results were analyzed by two-way ANOVA and Tukey test (alpha = 0.05). No difference was found between 24 h-PE and 1 yr-PE for OB, CP, SB, and PB. However, muTBS values significantly dropped after 1 yr-DE for SE, CP, SB, and PB. A decreased muTBS was seen in SE after 1 yr-PE, but no differences existed between 1 yr-PE and 1 yr-DE. Similar or increased muTBS values were noted in 1 yr-DOE for all adhesives. Water-storage for 1 year significantly decreased muTBS for all adhesives. However, except for SE, the presence of a peripheral composite-enamel bond seemed to reduce the degradation rate in resin-dentin interfaces for all materials.
 ...
PMID:Effects of a peripheral enamel bond on the long-term effectiveness of dentin bonding agents exposed to water in vitro. 1761 15


<< Previous 1 2 3 4 5 6 7 8 9 10 Next >>