Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0205700 (ash)
 15,125 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The oxalic acid-lithium carbonate-lithium tetraborate (1:1:1) fusion agent proposed previously for cement analysis is applied to determine the composition of various siliceous samples including granite, clay, flyash, sand and silica fume. For samples with silica content higher than 70%, the sample size had to be reduced from 0.10 to 0.01 g and a recovery factor was needed in silica determination to account for the precipitation of silica during acid dissolution. Attempt has also been made to determine the major metallic elements in coal by fusion directly without the ashing procedure, and the results obtained were good. Further, the ash content of coal was proposed to be determined by establishing a relation between the ash content and the sum of the concentrations of four major oxides (i.e. the oxides of Si, Al, Fe and Ca), and the proposed method is accurate and is time saving compared with that determined by direct ashing at 800 degrees C.
 ...
PMID:Analysis of siliceous materials and coal by atomic absorption spectrophotometry with fusion for sample decomposition. 1896 32

Incineration has become the main mechanism for hospital waste (HW) disposal in China after the outbreak of Severe Acute Respiratory Syndrome (SARS) in 2003. However, little information is available on the chemical properties of the resulting ashes. In the present study, 22HW ash samples, including 14 samples of bottom ash and eight samples of fly ash, were collected from four typical HW incineration plants located across China. Chemical analysis indicated that the HW ashes contained large amounts of metal salts of Al, Ca, Fe, K, Mg, Na with a concentration range of 1.8-315gkg(-1). Furthermore, the ashes contained high concentrations of heavy metals such as Ag, As, Ba, Bi, Cd, Cr, Cu, Mn, Ni, Pb, Ti, Sb, Sn, Sr, Zn with a vast range of 1.1-121,411mgkg(-1), with higher concentrations found in the fly ash samples. Sequential extraction results showed that Ba, Cr, Ni and Sn are present in the residual fraction, while Cd existed in the exchangeable and carbonate fractions. As, Mn, Zn existed in the Fe-Mn oxide fraction, Pb was present in the Fe-Mn oxide and residual fractions, and Cu was present in the organic matter fraction. Furthermore, toxicity characteristic leaching procedure (TCLP) results indicated that leached amounts of Cd, Cu and Pb from almost all fly ash samples exceeded the USEPA regulated levels. A comparison between the HW ashes and municipal solid waste (MSW) ash showed that both HW bottom ash and fly ash contained higher concentrations of Ag, As, Bi, Cd, Cr, Cu, Pb, Ti, and Zn. This research provides critical information for appropriate HW incineration ash management plans.
 ...
PMID:Chemical properties of heavy metals in typical hospital waste incinerator ashes in China. 1899 May 57

In this study, crab shells were recycled as an adsorbent for the removal of phosphate. The effects of shell particle size, temperature, pH and phosphate concentration on phosphate removal were investigated. Shell particles less than 1000 microm in diameter removed more than 85% of 500 mg/L phosphate in 24h while particles 3350 microm in diameter exhibited only 50% removal efficiency. Temperature showed negligible effect on phosphate removal in the range of 15-45 degrees C. Although removal efficiency was highest at pH 2.0, the efficiency remained 50-60% at pH of 4.0-10.0. The maximum removal capacity was calculated as 108.9 mg/g through Langmuir isotherm plotting, which was 17.0 and 4.7 times higher than those of coal fly ash and scallop shells, respectively. Although calcium carbonate played an active role in the removal of phosphate, both proteins composing 12.5% of crab shells and cellulose-like backbone of the crab shells also played an important role in phosphate removal.
 ...
PMID:Recycling wasted biomaterial, crab shells, as an adsorbent for the removal of high concentration of phosphate. 1914 14

Waste incineration fly ash was successfully recycled to calcium phosphate hydrogel, a type of fast proton conductor. The crystallized hydrogel from incineration fly ash had a lower electric conductivity and a lower crystallinity than that from calcium carbonate reagent. However, the difference in electric conductivity between these crystallized hydrogels decreases with temperature. This was due to the presence of potassium in the incineration fly ash. The fuel cell with a membrane electrode assembly (MEA) using the calcium phosphate hydrogel membrane prepared from incineration fly ash was observed to generate electricity. The performance of this fuel cell was almost equal to that of a mixture of K(2)CO(3) and CaCO(3) reagents; further, the performance of the former was superior to the fuel cell with a perfluorosulfonic polymer membrane at temperatures greater than approximately 85 degrees C.
 ...
PMID:Synthesis of calcium phosphate hydrogel from waste incineration fly ash and its application to fuel cell. 1930 68

Waste incineration fly ash and bone powder could be successfully recycled to calcium phosphate hydrogel, a type of fast proton conductor. The electric conductivity of the crystallized hydrogel from them was compared with that from calcium carbonate reagent. It was found that the conductivity of the hydrogel from bone powder is almost equal to that from calcium carbonate reagent, which is higher than that from incineration fly ash. Because the crystallized hydrogel from incineration ash has a lower crystallinity than that from bone powder and calcium carbonate reagent. However, the difference of the conductivity among them can be hardly observed above 100 degrees C. The fuel cell with membrane electrode assembly (MEA) using the calcium phosphate hydrogel membrane prepared from incineration fly ash and bone powder was observed to generate electricity. The performance of fuel cells having the hydrogel membrane obtained from all raw materials increases with the cell temperature, and the fuel cell containing the hydrogel membrane from incineration fly ash has the highest dependence of the fuel cell performance. For this reason, the difference in the cell performance among them can be hardly observed above 120 degrees C. This tendency agrees with the change in the electric conductivity with the temperature. Further, the performance of all fuel cells with the hydrogel membrane is superior to that of the fuel cell with perfluorosulfonic polymer membrane at temperatures greater than approximately 85 degrees C.
 ...
PMID:Performance of fuel cell using calcium phosphate hydrogel membrane prepared from waste incineration fly ash and chicken bone powder. 1932 27

This paper presents a new treatment procedure applied on phosphogypsum transport water. Untreated transport water is highly acidic (pH 1.79), having fluoride content of 1540 mg/L and elevated values of phosphates (215 mg/L) and heavy metals (Fe=25.8 mg/L; Zn=5.7 mg/L; Mn=2.7 mg/L, V=1.7 mg/L). Neutralization/purification of the transport water was carried out with wood fly ash, otherwise a rich source of calcium, composed of calcite, dipotassium calcium carbonate and hydroxylapatite. Maximum removal efficiency of fluoride was observed at pH 7 (99.99%) and phosphate at pH 9 (96.29%). The removal of fluorides was a consequence of the formation of fluorite and fluorapatite mineral phases derived from the reaction of calcium (released from the fly ash minerals) and fluorides (from the transport water). The removal of phosphates resulted from the formation of fluorapathite and hydroxilapatite. At the optimum conditions removal efficiencies for the elements Pb, V, Cr(VI), Mn, Fe, Ni, Cu, and Zn were 95%, 98.14%, 91.11%, 100%, 99.71%, 96.33%, 97.24%, and 99.65%, respectively. Optimal heavy metal removal occurred in major cases at pH 7.
 ...
PMID:Characterization and treatment of the phosphoric gypsum transport water. 1941 50

Two lab scale upflow anaerobic sludge bed (UASB) reactors were operated at an organic loading rate of COD 9 kg x (m3 x d)(-1) to treat two kinds of calcium containing wastewaters, one of which took acetic acid as substrate and for the other, glucose and soluble starch were the substrate. Both the wastewaters contained 800 mg x L(-1) Ca+. Precipitation of calcium carbonate in the reactors was observed. The results showed that the kind of substrate had great influence on calcium carbonate precipitation. In the reactor treating acetic acid containing wastewater, a maximum calcium precipitation rate of 65% was achieved and an average rate of about 25% was then maintained. In contrast, the calcium precipitation rate for the glucose and soluble starch containing wastewater was only about 7.5%. It was also found that substantial precipitation only occurred 30 days after the reactor were operated for both of the wastewaters. After 180 days of operation, the ash content of the sludge in the reactors increased from about 10% to 70% for the acetic acid containing wastewater and 30% for the other. However, the increase of ash content had no negative influence on the COD removal efficiency, which was kept at about 90% throughout the experimental period. By the SEM it was inferred that the different substrates caused the differences of the granular sludge microstructure, leading to the diversity of calcium carbonate precipitation in the two reactors.
 ...
PMID:[Calcium carbonate precipitation in UASB reactors with different substrates]. 1943 35

Calcium (Ca) supplements, especially Ca carbonate (CaCO3), are the main alternative sources of dietary Ca and an important part of a treatment regimen for osteoporosis, the most common metabolic bone disorder of aging and menopause. In a female ovariectomized (OVX) rat model for studying postmenopausal osteoporosis, we tested the hypothesis that a small compared with a large particle size of CaCO3 (13.0- vs. 18.5-mum geometric diameter) would result in increased Ca balance and subsequently bone mass and that this would be affected by dietary Ca level. We used 6-mo-old rats that were OVX either at 6 or 3 mo of age as models of early or stable menopausal status, respectively. The rats received semipurified diets that contained either 0.4 or 0.2% dietary Ca provided from CaCO3 of 2 particle sizes. A group of Sham-operated rats with intact ovaries served as control and were fed 0.4% dietary Ca from large particles. Estrogen deficiency as a result of ovariectomy had an adverse effect on bone density, mineral content, and bone mechanical properties (P < 0.001). Reducing dietary Ca from 0.4 to 0.2% resulted in significant adverse effects on bone density and mechanical properties (P < 0.001). The particle size of CaCO3 did not affect total Ca balance, bone dual energy X-ray absorptiometry and peripheral quantitative computed tomography indices, bone ash and Ca content, or the mechanical determinants of bone strength. We conclude that a decrease in particle size of CaCO3 to 70% of that typically found in Ca supplements does not provide a benefit to overall Ca metabolism or bone characteristics and that the amount of Ca consumed is of greater influence in enhancing Ca nutrition and skeletal strength.
 ...
PMID:Diet calcium level but not calcium supplement particle size affects bone density and mechanical properties in ovariectomized rats. 1947 56

In this work, medical waste (MW) incinerator fly ashes from different types of incinerators were subjected to supercritical water (SCW) and SCW+H(2)O(2) (SCWH) treatments. Sequential extraction experiments showed that, after SCW treatment, heavy metals in exchangeable and carbonate forms in the ashes could be transferred into other relatively stable forms, e.g., Ba and Cr into residual fraction, Cu and Pb into organic matter fraction. SCWH treatment could stabilize heavy metals in Fe-Mn oxides and residual fractions. However, the behavior of As was quite different from heavy metals, which could be leached out from residue fraction after SCW and SWCH treatments. The leached As tended to absorb onto Fe-Mn oxides and organic matters under near neutral environment, but it could react with Ca(2+) at lower pH, increasing the mobility of this element. Therefore, it is necessary to neutralize acidic ash to near neutral condition before subjecting it to SCW and SCWH treatments so as to effectively stabilize hazardous elements in the ash. Consequently, it is believed that SCWH treatment is an effective alternative for hazardous elements detoxification in MW fly ash.
 ...
PMID:Influence of supercritical water treatment on heavy metals in medical waste incinerator fly ash. 1948 22

Two pulp and paper industrial wastes, lime mud (LM) and recovery boiler ash (RB), have low moisture contents, low heavy metal contaminations and contain various carbonate compounds which contribute to a high pH. Metal finishing wastewater (MF-WW) has a low pH, high levels of TDS and high contaminations from Cr, Cu, Pb and Zn. The heavy metals from MF-WW were removed by sorption and precipitation mechanisms. LM gave better results in removing heavy metals from MF-WW than RB. At a reaction time of 45min, the maximum removal efficiencies for Cr (93%) and Cu (99%) were obtained at 110gL(-1) of LM, but at 80gL(-1) for Pb (96%) and Zn (99%). Treatment with LM gives a higher sludge volume than with RB. However, the leachability of heavy metals from LM is lower. Leachability of heavy metals in the sediment for all selected treatment conditions is within government standards.
 ...
PMID:Utilization of pulp and paper industrial wastes to remove heavy metals from metal finishing wastewater. 1950 52


<< Previous 1 2 3 4 5 6 7 8 9 10 Next >>