Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0205700 (ash)
 15,125 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

A metal-plating waste filter cake treated by stabilisation/solidification (S/S) using ordinary Portland cement (OPC) and pulverised fuel ash (PFA) has been characterised after exposure to the environment in SE England for approximately 10 years. The surface region ( approximately 5cm) was severely degraded, extensively carbonated and had reduced acid neutralisation capacity (ANC) compared to bulk samples. Large 'plate-like' deposits of predominantly calcium hydroxide with a calcium carbonate upper layer were found close to, but below the surface of the exposed S/S waste. Calcium zinc hydroxide (Ca(Zn(OH)(3))(2).2H(2)O) was the major crystalline phase found in the S/S waste in the region below the calcium hydroxide plates (10-15cm). Samples taken from the bulk of the environmentally exposed S/S waste, at a depth of approximately 0.5m, were more amorphous, contained no readily identifiable crystalline phases and had negligible strength but retained high acid neutralisation capacity. Metal analysis of homogenised samples taken from different depths into the S/S waste indicated a reduction in the concentration of heavy metals, such as Zn, Fe and Cr, in the top 5cm of the S/S waste and an increase in concentration of these metals in bulk samples. The majority of crystalline mineral phases detected in the 28-day samples were not identified in the 10-year-old samples.
 ...
PMID:Characterisation of environmentally exposed cement-based stabilised/solidified industrial waste. 1293 57

In recognition of the trend toward an increased use of bottom ash as construction material, the authors have investigated the feasibility of recovering bottom ash for use as aggregates, by sintering size-fractioned MSW incinerator bottom ash (particle size less than 1.41 mm and between 4.76-1.41 mm) at 400-1,000 degrees C for 60-240 min, and then determining the sintered material characteristics, such as the compressive strength, heavy metal leachability and principal material properties. The results indicate that the pH of the Toxicity Characteristic Leaching Procedure (TCLP) leachate produced from both fine and the coarse ash, ranged from 10.0-11.5, and from 7.5-11.3 respectively, and showed a tendency to decrease with an increasing sintering temperature. In addition, for both types of ash the compressive strength of the sintered monoliths, ranging from 50-55 MPa, decreased slightly when the sintering temperature was increased from 400 to 600 degrees C. Deformation problems may arise from the melting of glassy substances in the ash when bottom ash is sintered at temperatures higher than 700 degrees C. Thus, when sintered between 800 to 1,000 degrees C, the sintered bottom ash pellets might disintegrate due to the formation of aluminium and/or calcium salts. The decomposition of calcium carbonate at 650 degrees C which releases significant amounts of carbon dioxide, may also cause the destruction of a monolith. Based on considerations of loss on ignition, volume changes, water adsorption, soundness, bulk density and the compressive strength of the sintered ash, developed by the sintering of bottom ash between 400 to 600 degrees C after removing its coarse impurities, the general results from the experiments suggest that the aggregates do meet the Chinese National Standards (CNS) for permeable blocks.
 ...
PMID:The recycling of MSW incinerator bottom ash by sintering. 1453 18

In a semiarid environment, climate is a critical factor in the decomposition of surface-applied biosolids. This study examined the effect of 2- to 7-yr exposure times on the composition of single applications of New York, NY biosolids in western Texas. Exposure time effects on organic matter, N, P, S, Cu, Cr, Pb, Hg, and Zn were studied near Sierra Blanca, TX. Due to organic matter decomposition, total organic C decreased from 340 g kg(-1) in fresh biosolids to 180 g kg(-1) in biosolids after 82 mo of exposure, whereas the inorganic ash content of the biosolids increased from 339 to 600 g kg(-1). Total N decreased from 50 to 10 g N kg(-1) and total S decreased from 12 to 6 g S kg(-1). Bicarbonate-available P in the biosolids decreased from 0.9 to 0.2 g kg(-1). Successive H2O extractions yielded soluble P concentrations consistent with dicalcium phosphate (dical) for fresh biosolids and tricalcium phosphate (trical) for biosolids exposed for 59 months or more. Sparingly soluble phosphates, such as dical and trical, potentially yield > 0.5 mg P L(-1) in runoff waters for extended periods after biosolids applications, especially after multiple applications. Selective dissolution of the biosolids indicated that as much as 66 to 78% of P exists as iron phosphates, 16 to 21% as Fe oxides, and 5 to 12% as insoluble Ca phosphates. Chemical analyses of ash samples suggest that Cu and Zn have been lost from biosolids through leaching or runoff and no losses of Pb, Cr, or Hg have occurred since application.
 ...
PMID:Biosolids decomposition after surface applications in west Texas. 1453 20

Experiments were carried out on laboratory-scale pulverized coal combustion with different adsorbents. Three solid adsorbents (calcium sulfate, limestone and bauxite) were used to control the emission of heavy metals (Pb, Cd, Cu, Co, Ni) during coal combustion. Sequential extraction procedure was developed for partitioning of metals species in coal ash into five fractions: absorbable metals, exchangeable metals, metals bound to carbonate, metals bound to sulfate, residual metals. The adsorbents showed a certain adsorptive ability to heavy metals, and different adsorbent had different ability. It can be proved from the distribution of heavy metals between coarse ash residues and fine particles and also from the increment of stable speciation of heavy metals in fine particles. Calcium sulfate was effective sorbent for removal of Pb, Cd and Cu, limestone for removal of Pb, Cd, Cu, Ni, and bauxite for removal of these five heavy metals. Fine adsorbents have higher adsorptive ability than coarse adsorbents.
 ...
PMID:[Effects of solid adsorbents on the emission of heavy metals during coal combustion]. 1471 55

A field experiment was conducted to determine the effect of fly ash from a coal combustion electric power facility on soil acidity in a cotton (Gossypium hirsutum L.) field. Fresh fly ash was applied to a Bosket fine sandy loam (fine-loamy, mixed, thermic Mollic Hapludalf) soil with an initial soil pH(salt) of 4.8. The fly ash was equivalent to 42 g kg(-1) calcium carbonate with 97% passing through a 60 mesh (U.S. standard) sieve. Fly ash was applied one day before cotton planting in 1999 at 0, 3.4, 6.7, and 10.1 Mg ha(-1). No fly ash was applied in 2000. Within 60 d of fly ash application in 1999, all rates of fly ash significantly increased soil pH above 6.0. Manganese levels in cotton petioles were reduced significantly by 6.7 and 10.1 Mg ha(-1) of fly ash. Soil boron (B) and sodium (Na) concentrations were significantly increased with fly ash. In 1999, B in cotton leaves ranged from 72 to 84 mg kg(-1) in plots with fly ash applications. However, no visual symptoms of B toxicity in plants were observed. In 1999, cotton lint yield decreased on average 12 kg ha(-1) for each Mg of fly ash applied. In 2000, cotton yields were significantly greater for the residual 3.4 and 6.7 Mg fly ash ha(-1) plots than the untreated check. Due to the adverse yield effects measured in the first year following application, fly ash would not be a suitable soil amendment for cotton on this soil at this time.
 ...
PMID:Fly ash as a liming material for cotton. 1496 89

A gradual increase in fly ash concentrations in the normal field soil (0, 10, 20...100% volume/volume) increased the porosity, water holding capacity, pH, conductivity, C.E.C., sulphate, carbonate, bicarbonate, chloride, P, K, Ca, Mg, Mn, Cu, Zn and B. Fly ash additions to soil caused significant reductions in nitrogen content, it being almost nil in 90 and 100%. Tomato plants grown in the ash-soil mixture showed luxuriant growth with bigger and greener leaves. Plant growth, yield, (flowering, fruiting, fruit weight/plant, mean fruit weight), carotenoids and chlorophylls were mostly enhanced in the treatments with 40-80% fly ash, being optimal at 50 or 60%. From 60 or 70% onwards, the measured parameters tended to reduce. At 100% fly ash, yield (weight of fruits/plant) was considerably reduced. The boron content of tomato leaves displayed a gradual increase with fly ash addition from 20% onwards, while response of foliar nitrogen was just the opposite. The most economic level of fly ash incorporation was 40%, which improved the yield and market value of tomato fruits (mean weight) by 81 and 30%, respectively.
 ...
PMID:The effect of fly ash on plant growth and yield of tomato. 1509 90

The burning of a papermill sludge and wood mixture and landspreading the resulting ash is a potential means of disposal of papermill sludge without the use of valuable landfill space. This study evaluated the effectiveness of ashes derived from a mixture of papermill sludge and wood sources to act as an alternative liming agent. The calcium carbonate equivalence of the material was determined using a 91-day laboratory incubation test with three mineral soils and one organic horizon soil. Application rates of soil-incorporated sludge-ash ranged from 2.30 to 32.2 g per kg soil. Soil pH increased linearly with increasing sludge-ash application rate. The calcium carbonate equivalence of the material varied temporally and the average value ranged from 19% to 28%. The fraction of total P, K and Mg added with the sludge-ash and extracted from the ash-amended soils using an NH4OAc based soil test method were 2.6, 3.8 and 17.6%, respectively. The low soil test extractability of ash-derived plant nutrients suggests that this material would provide only a modest increase in plant available nutrient levels in landspread fields.
 ...
PMID:Incubation-derived calcium carbonate equivalence of papermill boiler ashes derived from sludge and wood sources. 1509 2

A study was conducted to determine the acceptability of porridge developed from various proportions of soy and sorghum. Partially defatted soydhal was soaked in four salt solutions namely, sodium carbonate, sodium bicarbonate, sodium tripolyphosphate and sodium chloride. Soaked dhal was dried and made into grits. Soy and sorghum grits were mixed in three proportions i.e. 10:90, 20:80 and 30:70 to develop nutritious porridge. Porridge prepared from wheat grits served as a control. The sensory evaluation of the developed porridge was done using a 9-point hedonic scale. Porridge prepared using sodium carbonate soaked soydhal was found to fall in the 'like slightly' category whereas other three types of porridges as well as control porridge were 'liked moderately' by the panellists. Nutritional evaluation of the developed porridge demonstrated that protein, fat, crude fibre and ash contents increased significantly (P < 0.05) as the level of soy was increased from 10 to 20 and 30 per cent.
 ...
PMID:Nutritional and sensory evaluation of nutritious porridge prepared using combinations of soy and sorghum grits. 1517 38

The aim of the present study in cats was to investigate the potential effects of a calcium carbonate and chitosan supplement on blood parameters in aged cats with moderate chronic renal failure and on the mineral balance in adult healthy cats. For the trials, 10 neutered cats 2-4 years of age were fed for 21 days and six neutered cats (2 male and 4 female), 14 years of age, with elevated urea and phosphorus level in the plasma were fed for 35 days with a supplement. The apparent digestibility of phosphorus was (p < 0.05) reduced in the treatment period. Plasma urea inorganic phosphate decreased significantly (p < 0.05) in the old cats after 35 days of treatment. The treatment had a significant effect on the phosphorus, gross energy, dry matter, crude ash, crude fiber and crude protein digestibility in adult healthy cats. The practical implication could be an alternative treatment option for cats refusing to ingest veterinary renal diets.
 ...
PMID:Effects of a dietary chitosan and calcium supplement on Ca and P metabolism in cats. 1529 59

In this study, four cultivars of sunflower (Helianthus annuus) were grown in the sandy loam soil, supplemented with graded (v/v) quantity (0, 20, 40, 60, 80, 100%) of the fly ash, released by the combustion of the coal from the thermal power plant. The presence of fly ash in the soil increased its porosity, water holding capacity, pH, E.C., C.E.C., the content of sulphate, carbonate, bicarbonate, chloride, phosphorus, potassium, calcium and various trace elements. However, in the seeds, except Fe, Pb, Mn and Zn, and other heavy metals remained untraced up to 40% of the fly ash, above that their quantity slightly increased but the values are very much under the permissible limits.
 ...
PMID:The fly ash influenced the heavy metal status of the soil and the seeds of sunflower. A case study. 1530 5


<< Previous 1 2 3 4 5 6 7 8 9 10 Next >>