Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0016382 (flushing)
 6,387 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Entrapped and pooled dense nonaqueous-phase liquids (DNAPLs) often persist in aquifers and serve as a long-term source of groundwater contamination. To address the problematic nature of DNAPL remediation, a surfactant-enhanced aquifer remediation (SEAR) technology, density-modified displacement (DMD), has been developed which significantly reduces the risk of downward migration of displaced DNAPLs. The DMD method is designed to accomplish DNAPL density conversion through the introduction of a partitioning alcohol, n-butanol (BuOH), in a predisplacement flood using conventional horizontal flushing schemes. Subsequent displacement and recovery of the resulting LNAPL is achieved by flushing with a low-interfacial tension surfactant solution. The objective of this study was to investigate density conversion of two representative DNAPLs, chlorobenzene (CB) and trichloroethene (TCE). A series of batch experiments was performed to assess changes in NAPL composition, density, and phase behavior as a function of BuOH mole fraction. Experimental results were used to develop contaminant/BuOH/water ternary phase diagrams and to elucidate regions of contrasting NAPL density. UNIQUAC calculations are presented to support measured compositional and phase behavior data. Density conversion of CB and TCE, relative to water, occurred at NAPL BuOH mole fractions of 0.38 and 0.50, respectively. Significant incorporation of water into the organic phase was observed at relatively high BuOH mole fractions and was shown to limit changes in NAPL composition and density. Interfacial tensions between CB-NAPL and TCE-NAPL and a 6% (by wt) BuOH aqueous solution were found to decrease with increasing NAPL BuOH mole fraction, although in both cases the measured values remained above 2.5 dyn/cm. Total trapping number calculations suggest that, in most aquifer formations, density conversion can be achieved without premature NAPL displacement using a 6% (by wt) BuOH aqueous solution.
 ...
PMID:Density-modified displacement for dense nonaqueous-phase liquid source-zone remediation: density conversion using a partitioning alcohol. 1202 97

Low interfacial tension (IFT) displacement (mobilization) of nonaqueous phase liquids (NAPLs) offers potential as an efficient remediation technology for contaminated aquifer source zones. However, displacement of dense NAPLs (DNAPLs) is problematic due to the tendency for downward migration and redistribution of the mobilized DNAPL. To overcome this limitation, a density-modified displacement method (DMD) was developed, which couples in situ density conversion of DNAPLs via alcohol partitioning with low IFT NAPL displacement and recovery. The objective of this work was to evaluate the DMD method for two representative DNAPLs, chlorobenzene (CB) and trichloroethene (TCE). Laboratory-scale experiments were conducted in a two-dimensional (2-D) cell, configured to represent a heterogeneous unconfined aquifer system containing low permeability lenses. After release and redistribution of either CB- or TCE-NAPL, the 2-D aquifer cells were flushed with a 6% (wt) n-butanol aqueous solution to achieve DNAPL to light NAPL conversion, followed by a low IFT surfactant solution consisting of 4% (4:1) Aerosol MA/Aerosol OT + 20% n-butanol + 500 mg/L CaCl2. Visual observations and experimental measurements demonstrated that in situ density conversion and immiscible displacement of both CB and TCE were successful. Effluent NAPL densities ranged from 0.96 to 0.90 g/mL for CB and from 0.95 to 0.92 g/mL for TCE, while aqueous phase densities remained above 0.96 g/L. Density conversion of CB and TCE was achieved after flushing with 1.2 and 4.9 pore vol of 6% n-butanol solution, respectively. Recoveries of 90% CB and 85% TCE were realized after flushing with 1.2 pore vol of the low IFT surfactant solution, which was followed by a 1 pore vol posttreatment water flood. Surfactant and n-butanol recoveries ranged from 75 to 96% based on effluent concentration data. The observed minimal mobilization during the n-butanol density conversion preflood and near complete mobilization during the low IFT displacement flood were consistent with total trapping number calculations. The results reported herein demonstrate the potential efficiency of the DMD technology as a means of DNAPL source zone restoration.
 ...
PMID:Density-modified displacement for DNAPL source zone remediation: density conversion and recovery in heterogeneous aquifer cells. 1214 1

Flow-through aquifer columns were operated for 12 weeks to evaluate the benefits of aerobic biostimulation for the bioremediation of source-zone soil contaminated with chlorobenzenes (CBs). Quantitative Polymerase Chain Reaction (qPCR) was used to measure the concentration of total bacteria (16S rRNA gene) and oxygenase genes involved in the biodegradation of aromatic compounds (i.e., toluene dioxygenase, ring hydroxylating monooxygenase, naphthalene dioxygenase, phenol hydroxylase, and biphenyl dioxygenase). Monochlorobenzene, which is much more soluble than dichlorobenzenes, was primarily removed by flushing, and biostimulation showed little benefit. In contrast, dichlorobenzene removal was primarily due to biodegradation, and the removal efficiency was much higher in oxygen-amended columns compared to a control column. To our knowledge, this is the first report that oxygen addition can enhance CB source-zone soil bioremediation. Analysis by qPCR showed that whereas the biphenyl and toluene dioxygenase biomarkers were most abundant, increases in the concentration of the phenol hydroxylase gene reflected best the higher dichlorobenzene removal due to aerobic biostimulation. This suggests that quantitative molecular microbial ecology techniques could be useful to assess CB source-zone bioremediation performance.
 ...
PMID:Aerobic bioremediation of chlorobenzene source-zone soil in flow-through columns: performance assessment using quantitative PCR. 1796 Apr 85

The octadecylamine-capped gold nanoparticles (ODA-Au-NPs) were prepared and directly used to coat the capillary wall. The hydrophobic coating acted as the stationary phase for open-tubular gas chromatography (OTGC). The ODA-Au-NPs can be adsorbed tightly onto the inner surface of fused silica capillary column via electrostatic interaction and enhanced interaction of van der Waals between gold nanoparticles and the capillary wall. Thus, the modification of the inner surface of capillary column by ODA-Au-NPs can be achieved simply by flushing the capillary with a solution of ODA-Au-NPs and the resulted ODA-Au-NPs coating is very stable. No perceptible degradation in the ODA-Au-NPs-based separation was observed after approximately 1900 sample runs. This type of columns also provided excellent chromatographic performances: high number of theoretical plates, outstanding run-to-run and column-to-column reproducibility, and high selectivity for a wide range of test mixtures. An efficiency of 2474 theoretical plates per meter for chlorobenzene was obtained on an ODA-Au-NPs-modified 1.6 m x 100 microm i.d. fused silica capillary column.
 ...
PMID:Open-tubular gas chromatography using capillary coated with octadecylamine-capped gold nanoparticles. 1824 76