Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0016382 (flushing)
 6,387 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The amounts of halothane and isoflurane trapped after exposure for up to 3 h at 2 MAC in commonly used anaesthesia circuit tubing were quantitated by gas chromatography. The decontaminating effects of procedures such as flushing with oxygen, thermal disinfection and/or routine storage were assessed in a similar way. After halothane exposure, anaesthetic content was highest in silicone (398 +/- 55 mg 100 g-1). Lower quantities were found in all other tubings investigated (electrically conductive latex: 64 +/- 4, conductive rubber: 62 +/- 4, polyethylene-vinyl-acetate (PEVA): 293 +/- 10 and 149 +/- 17 for non-conductive corrugated and spiral tubes, respectively, polysulfone (Hytrel): 155 +/- 10 mg 100 g-1). The isoflurane contents were substantially lower (silicone: 278 +/- 23; others: 55 +/- 7, 61 +/- 6, 163 +/- 9 and 86 +/- 8, 74 +/- 4 mg 100 g-1). The tubings' content did not correlate with the material's partition coefficient as full saturation was not achieved during exposure. Decontamination procedures reduced the content of volatile anaesthetics to a variable extent. Conductive latex and rubber showed the highest residual content, even after thermal disinfection and subsequent storage. Twenty-minute flushing with oxygen (8 l min-1) decreased effluent gas concentrations below 5 p.p.m. in all tubings. With silicone, after 1 h flushing, halothane concentrations still exceeded 10 p.p.m. (isoflurane: 8 p.p.m.). It is concluded that urgent decontamination by a 20-min flush warrants the safe re-use of previously 'contaminated' conductive rubber and latex as well as polysulfone tubings in critical situations, e.g. in malignant hyperthermia patients if disposable tubing is not immediately available.(ABSTRACT TRUNCATED AT 250 WORDS)
 ...
PMID:Anaesthetic uptake and washout characteristics of patient circuit tubing with special regard to current decontamination techniques. 144 61

The anaesthetic management for Caesarean delivery of a parturient with a strong family history of malignant hyperthermia (MH) is presented. Before surgery an anaesthetic machine that was in regular use was prepared by replacing all rubber or disposable components and flushing with O2 at 10 L.min-1 for one hour. Dantrolene prophylaxis was not used, and the patient received a bupivacaine and fentanyl spinal anaesthetic. Hypotension was treated with ephedrine. Current management of the MH patient no longer mandates a dedicated vapour-free machine, dantrolene is not indicated as pre-treatment, and amide local anaesthetics are considered safe. The role of vasopressors and ergot preparations is less clear.
 ...
PMID:Anaesthesia for caesarean delivery of a malignant hyperthermia susceptible parturient. 786 20

Anaesthetic machines are prepared for use with patients who are susceptible to malignant hyperpyrexia (MH) by flushing with oxygen at 10 l/min for ten minutes to reduce the anaesthetic concentration to 1 part per million (ppm) or less. Anaesthetic workstations are now often used in place of traditional machines. Workstations have greater internal complexity, and it is not known if they can be made safe for susceptible patients by flushing with oxygen. We used a high sensitivity infrared gas analyser to measure the washout of isoflurane from five Datex-Ohmeda workstations. Measurements were then repeated with a patient breathing circuit. Isoflurane washout occurred in an exponential manner. The time to reach a concentration of 1 ppm at the fresh gas outlet was 17 +/- 7 minutes, and all machines had reached less than 2 ppm by ten minutes. The washout of isoflurane from the machine and patient breathing circuit was much slower than from the machine alone, with a concentration less than 2 ppm reached only after 30 minutes. We conclude that the Datex-Ohmeda workstation can be prepared for use in MH susceptible patients by flushing with oxygen at 10 l/min for ten minutes. Flushing of the patient breathing system is not straightforward, and we recommend using a clean T-piece circuit. If the circle system and ventilator are required for anaesthesia, we suggest using new breathing hoses, rebreathing bag and soda lime cartridge, and ventilating an artificial lung for 30 minutes with a fresh gas flow rate of 10 l/min and tidal volume of 1 litre.
 ...
PMID:Preparing a new generation anaesthetic machine for patients susceptible to malignant hyperthermia. 1263 97

Malignant hyperthermia (MH) is a life-threatening condition caused by exposure of susceptible individuals to volatile anaesthetics or suxamethonium. MH-susceptible individuals must avoid exposure to these drugs, so accurate and reproducible processes to remove residual anaesthetic agents from anaesthetic workstations are required. Activated charcoal filters (ACFs) have been used for this purpose. ACFs can reduce the time for preparing an anaesthetic workstation for MH patients. Currently, the only commercially available ACFs are the Vapor-Clean$trade; (Dynasthetics, Salt Lake City, UT, USA) filters which retail at approximately AUD$130 per set of two, both of which are to be used in a single anaesthetic. Anaesthetic workstations were saturated with anaesthetic vapours and connected to a Miran ambient air analyser (SapphRe XL, ThermoScientific, Waltham, MA, USA) to measure vapour concentration. Various scenarios were tested in order to determine the most economical configurations of machine flushing, component change and activated charcoal filter use. We found that placement of filters in an unprepared, saturated circuit was insufficient to safely prepare an anaesthetic workstation. Following flushing of the anaesthetic workstation with high-flow oxygen for 90 seconds, a circuit and soda lime canister change and the placement of an ACF on the inspiratory limb, we were able to safely prepare a workstation in less than three minutes. A single filter on the inspiratory limb was able to maintain a clean circuit for 12 hours, with gas flows dropped from 10 lpm to 3 lpm after 90 minutes or removal of the filter after 90 minutes if high gas flows were maintained.
...
PMID:Clarifying the role of activated charcoal filters in preparing an anaesthetic workstation for malignant hyperthermia-susceptible patients. 2534 16