Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: UMLS:C0011860 (type 2 diabetes)
 57,723 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The purpose of this in vitro investigation was to examine the degree of microleakage in class II, MOD, posterior composite resin restorations, in the distal wall of which a layer of 1,5 mm of ceramometallic cement was condensed. Conventional MOD cavities were prepared using 330 and 56 tungsten carbide burs in 20 premolars extracted for orthodontic reasons. In the first group (10 specimens) the gingival floor was located in the enamel, above the cementoenamel junction and in the second group the gingival floor was located below the CEJ. In the mesial box, cervically, a layer of 1,5 mm of ceramometallic cement (Ketac Silver) was condensed and etched with orthophosphoric acid 37%, the cavity was filled with posterior composite resin (Heliomolar, Vivadent) and 24 hours later the specimens were polished using Sof-Lex discs and thermocycled between 4 degrees C and 60 degrees C for 50 cycles of 2 minutes each. The specimens were immersed for 2 hours in 2% basic fuchsin solution, washed, cleaned with acetate solution and split in two halves longitudinally in a mesiodistal direction, using a hard tissue microtome. From the detection of the degree of dye penetration we conclude that: a) In the cervical walls located in cementum, where cermet cement was condensed, minimal dye penetration was detected b) In the opposite side, where the composite resin existed on dentin-cementum, the dye penetration is more severe c) Dye penetration in cavities located in the enamel, is moderate in the areas where cermet cement existed d) No dye was detected in the interface between cermet cement and posterior composite, in most specimens.
 ...
PMID:[Microleakage pattern around posterior composite resin restorations, combined with a ceramometallic cement (sandwich technique)]. 213 Mar 14

The extent of microleakage under MOD composites was studied when an aluminum oxalate dentin bonding agent (Tenure), a phosphonated resin bonding agent (Bondlite), and a glass-ionomer cement (Ketac Silver) were used. Three groups of 10 extracted molars were prepared with MOD cavities; one box ended on enamel, the other on cementum. In Group 1, Bondlite was applied to dentin and etched enamel before the sample was restored with a light-cured hybrid composite. In Group 2, a 2-mm increment of Ketac Silver was placed in each box before Bondlite and composite. In Group 3, Tenure was applied to dentin before being restored. Teeth were thermal-cycled, stained in silver nitrate, sectioned, and scored for microleakage. Microleakage along the gingival floor was significantly less at enamel margins than at cementum margins in all three groups. All groups showed severe marginal microleakage on cementum.
 ...
PMID:Microleakage in MOD resin composite with three dentin bonding agents. 270 Sep 71

The purpose of this in vitro study was to evaluate the microleakage of indirect composite inlays and to compare leakage of inlays with directly placed composite restorations. Standardized MOD preparations were cut in 50 extracted human molars. One gingival margin was placed in enamel above the CEJ, and the other was placed in dentin below the CEJ. Two groups of teeth were directly filled with composites (P-30 and Heliomolar) after being etched, and dentin bonding agents were applied. Two groups of teeth were restored with composite inlays that were fabricated on stone dies. The inlays were made and luted with the same two composites. The last group of teeth was restored with Heliomolar inlays luted with Dual cement. The specimens were thermocycled 300 times between 5 and 50 degrees C. Microleakage was evaluated by use of the silver-nitrate staining technique. The depth of leakage was measured microscopically after the teeth were sectioned. Both direct restorations and inlays showed substantial leakage at gingival-dentin margins; however, there was only superficial leakage at enamel margins. P-30 inlays and Heliomolar inlays cemented with Dual leaked less than direct restorations at the gingival-dentin margins. There was no difference in leakage of enamel margins of inlays and direct restorations, except that direct Heliomolar restorations leaked more than the others. There was no difference in leakage between Heliomolar restorations luted with light-cured or dual-cured cement.
 ...
PMID:Microleakage of indirect composite inlays. 270 Sep 73

A case of sulindac-induced toxic epidermal necrolysis (TEN) is described; the etiology, symptoms, and treatment of TEN are reviewed; and sulindac's pharmacokinetic characteristics and other adverse effects are discussed. A 62-year-old black woman was given a prescription for sulindac 150 mg twice daily to relieve pain associated with degenerative joint disease. She also had a nine-year history of type II diabetes mellitus that was being managed with tolbutamide 500 mg once daily. After two weeks of sulindac therapy she developed a rash that spread over her entire body. Sulindac therapy was discontinued, and one day later the patient was admitted to the hospital with a temperature of 104.6 degrees F, conjunctivitis, and an erythematous macular rash over 60% of her body. Initially, therapy included prednisone 160 mg orally every day, applications of silver sulfadiazine cream four times daily for two days, and methylcellulose 0.5% ophthalmic solution (two drops four times daily) for the conjunctivitis. She also received intravenous hydration. By the fifth hospital day the patient's skin lesions and conjunctivitis had improved to the point that the prednisone dosage was tapered to 120 mg, then to 80 mg, and then to nothing over the following three days. Her diabetes was managed by short-term treatment with NPH insulin; however, before discharge, tolbutamide therapy was reinstituted, and insulin was discontinued. At follow-up four weeks after discharge, the patient's skin was largely clear. TEN has multiple etiologies, but the basic mechanism of injury is believed to be an immunological reaction directed at the basal cell layer.(ABSTRACT TRUNCATED AT 250 WORDS)
 ...
PMID:Sulindac-induced toxic epidermal necrolysis. 323 97

The aim of this study was to evaluate the variations in microleakage of large Class II (MOD) restorations over time. Three different combinations of dentine bonding agents and posterior resin composites which had previously shown promise were used: Vitrebond/Scotchbond 2 plus P50, Tripton plus Occlusin and Clearfil Photo Bond plus Clearfil Photo Posterior. Conventional Class II cavities were prepared in freshly extracted third molars. All gingival margins were terminated at the cemento-enamel junction. A fluid-under-pressure apparatus connected with the pulp chamber of each tooth was used to evaluate the permeability and marginal leakage of the restorations at 0.069 MPa. Microleakage was tested after insertion of restorations at 2, 15, 45, 150 min, after 1, 2, 7, 14 days, after 1, 2, 3 months, after thermal cycling and 10 months later, after occlusal loading. Finally, all specimens were exposed to silver nitrate solution to measure microleakage as dye penetration. Immediately after insertion of the restorations, all the materials showed a higher microleakage than after 1-2 days. After 4-8 weeks, all the restorations exhibited an increased permeability suggesting that hygroscopic expansion was not sufficient to keep pace with hydrolytic degradation of the restorations. Neither thermocycling or occlusal stresses increased the microleakage of the restorations.
 ...
PMID:Permeability and microleakage of Class II resin composite restorations. 815 12

Postnatal development of islet cells was morphometrically studied during neonatal (0, 1, 3, 5, and 7 days post partum << p.p. >>) and adult periods in Wistar and Sprague-Dawley rats, using two sensitive immunostainings, immunogold silver and protein A gold silver techniques. Nonfasted and fasted plasma glucose levels were also measured in adults. In addition, the frequency of developing type 2 diabetes was surveyed following injection of streptozotocin to neonates (2 days p.p.) of Wistar and Sprague-Dawley rats. The following results were obtained: 1) Islets grew more rapidly in Wistar than in Sprague-Dawley rats; 2) Increased percent areas of A and D cells and decreased percent area of B cells occurred during neonatal period in both Wistar and Sprague-Dawley rats; 3) Higher percent area of A cells and lower percent area of B cells were observed in Sprague-Dawley than in Wistar rats; 4) The duodenal pancreas of Wistar rats exhibited a marked neonatal increase in the percent area of pancreatic polypeptide (PP) cells and; 5) Sprague-Dawley rats were more susceptible to streptozotocin-induced type 2 diabetes, as compared with Wistar rats. An assumption is proposed that the differences in islet cell development between these rat strains are reflected in diabetes morbidity data.
 ...
PMID:A morphometrical study of the postnatal development of rat pancreatic islets, with special regard to the differences between Wistar and Sprague-Dawley strains. 833 33

This study evaluated the fracture resistance of maxillary premolars with MOD Class II cavity preparations restored with silver amalgam (G1), Scotchbond Multi Purpose Plus and silver amalgam (G2) and Panavia F and silver amalgam (G3). After the restorations were made, the specimens were stored at 37 degrees C for 24 hours at 100% humidity and submitted to the compression test. Statistical analysis of the data (ANOVA and Tukey Test) revealed no significant differences among the three groups that were studied.
 ...
PMID:Fracture resistance of teeth restored with the bonded amalgam technique. 1155 Oct 17

The association of tumor necrosis factor (TNF) with diabetic retinopathy (DR) has been described previously. A total of 207 Asian Indian patients of 15-year duration of type 2 diabetes were identified. This group included (i) 100 patients with DR and (ii) 107 patients without retinopathy (DNR). In this study, we correlated the length of the (GT)n microsatellite di-nucleotide repeat upstream to the promoter region of TNF gene with susceptibility for the development of retinopathy. The microsatellite was polymerase chain reaction amplified and electrophoresed on polyacrylamide gel and silver stained. In our study population, there were 18 alleles ranging from 97 to 131 base pairs (bp). Allele 4 (103 bp) had a higher prevalence (9.81%) in the DNR group compared to that (2.5%) in the DR group (P=0.002). Patients with retinopathy and allele 8 (111 bp) had a tendency to develop proliferative diabetic retinopathy (PDR). In this study of Indian subjects, it is suggested that allele 4 is a low risk allele for developing retinopathy and allele 8 (111 bp) shows an association with PDR.
 ...
PMID:Tumor necrosis factor allelic polymorphism with diabetic retinopathy in India. 1164 Sep 92

This study evaluated the fracture resistance of maxillary premolars with MOD cavity preparation and simulated periodontal ligament. The teeth were restored with silver amalgam (G1), Scotchbond Multi-Purpose Plus and silver amalgam (G2) and Panavia F and silver amalgam (G3). After restorations were made, the specimens were stored at 37 degrees C for 24 hours at 100% humidity and submitted to the compression test in the Universal Testing Machine (Instron). The statistical analysis of the results (ANOVA and Tukey Test) revealed that the fracture resistance of group 2 (G2=105.720 kgF) was superior to those of groups 1 (G1=72.433 kgF) and 3 (G3=80.505 kgF) that did not differ between them.
 ...
PMID:Fracture resistance of premolars with bonded class II amalgams. 1212 Jul 71

The objectives of this study include comparing the cement thickness and microleakage of Class II ceramic inlays built with three ceramic systems and verifying whether there was a correlation between those two variables. The ceramic systems used include: 1) Heat-pressed (IPS-Empress); 2) CAD-CAM (CEREC 2) and 3) Sintered (Colorlogic). Standardized MOD Class II inlay cavities with one proximal box extending below and the other extending above the cement-enamel junction (CEJ) were prepared in 30 extracted human molars and randomly assigned to three groups. The ceramic inlays were constructed according to manufacturer's instructions and cemented using a dual-cure resin cement (Variolink II). All teeth were mechanically cycled (100,000 cycles, 78N) and thermocycled (700 cycles, 5 degrees C-55 degrees C). After immersion in silver nitrate, the inlays were sectioned mesial-distally and evaluated with an optical microscope (40x). The cement thickness obtained by the Colorlogic system (enamel: 113 +/- 25 microm; dentin: 118 +/- 23 microm) was significantly higher than that obtained by CEREC (enamel: 78 +/- 14 microm; dentin: 87 +/- 13 microm) and Empress (enamel: 65 +/- 15 microm; dentin: 89 +/- 14 microm). Regarding dye penetration, there was no statistical difference among the three ceramic systems in enamel. At the dentin margins, the Colorlogic system resulted in a significantly higher penetration depth compared to CEREC and Empress, which had similar average values. No correlation was found between cement thickness and microleakage either in enamel or dentin for any of the ceramic systems.
 ...
PMID:Correlation between microleakage and cement thickness in three Class II inlay ceramic systems. 1508 34


1 2 3 4 5 6 7 8 9 10 Next >>