Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: KEGG:D01931 (TiO2)
 11,320 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Ultrasonic-hydrothermal and hydrothermal treatment was used for synthesis of nanocrystalline zirconia, titania, nickel and nickel-zinc ferrites powders from precipitated amorphous zirconyl, titanyl, binary nickel-iron and ternary nickel-zinc-iron hydroxides, respectively. Resulted nanopowders were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), nitrogen adsorption (BET), and magnetic susceptibility measurements. It was established that ultrasonically assisted hydrothermal treatment of amorphous zirconyl and titanyl gels results in significant rise of the rate of ZrO2 and TiO2 crystallization and promotes formation of thermodynamically stable monoclinic zirconia, but does not affect the microstructure and mean particles size of resulting nanopowders. Ultrasonic-hydrothermal processing of co-precipitated amorphous nickel, zinc and iron hydroxides favours formation of nanocrystalline ferrite powders with narrower particle size distribution.
 ...
PMID:Ultrasonically assisted hydrothermal synthesis of nanocrystalline ZrO2, TiO2, NiFe2O4 and Ni0.5Zn0.5Fe2O4 powders. 1622 87

Photocatalytic degradation of methyl parathion was done using a circulating TiO2/UV and TiO2/solar reactor. Indoor experimental results showed that, under the photocatalysis conditions, parathion was more effectively degraded than under the photolysis and TiO2 only conditions. Parathion (38 microM) was completely degraded under photocatalysis within 90 min, and more than 80% TOC decrease after 150 minutes. The main ionic byproducts during the photocatalysis were measured, and almost complete nitrogen recovery was achieved as mainly NO3- NO2-, and NH4+, and 80% of sulfur as recovered as SO4(2)-. Organic intermediates such as nitrophenol and methyl paraoxon were also identified during the photocatalysis of parathion, and these were further degraded after 90 minutes. Microtox bioassay using Vibrio fischeri was used in evaluating the toxicity of solutions treated by photocatalysis and photolysis of parathion. The results showed that the acute toxicity expressed as EC50 almost reduced after 90 min under the photocatalysis condition whereas only 40% reduction of toxicity as EC50 was achieved in photolysis condition. The outdoor results using a TiO2/solar system were similar to the TiO2 indoor system, indicating the possibility of applying TiO2/solar system for the treatment of parathion-contaminated water.
 ...
PMID:Degradation of parathion and the reduction of acute toxicity in TiO2 photocatalysis. 1631 50

N-doped TiO2 photocatalysts were prepared by pretreating the TiO2 precursor in NH3/ethanol fluid under supercritical conditions, denoted as TiO2N(SC). In contrast to the TiO2N(DC), obtained via direct calcination in which the N dopants were mainly present in the form of surface adsorbed NH3 molecules, most N dopants in the TiO2N(SC) were present in O-Ti-N and N-Ti-N nitrides, as confirmed by either the X-ray photoelectron spectroscopy (XPS) and or the Fourier transform infrared (FTIR) spectra. During liquid-phase oxidative degradation of phenol under irradiation with UV light characteristic of 365 nm, the TiO2N(SC) exhibited much higher activity than either the TiO2N(DC) or the TiO2(SC), i.e., the undoped TiO2 obtained under SCs. According to various characterizations including X-ray diffraction, transmission electron microscopy, FTIR, Brunauer-Emmett-Teller, XPS, and UV-vis diffuse reflectance spectra, the higher activity of the TiO2N(SC) could be attributed to its higher surface area, larger pore volume, well-crystallized anatase, and stronger absorbance of light with longer wavelength. Meanwhile, the OH species resulted from the nitridation of TiO2 could supply more HO* radicals, which were considered as powerful oxidants during phenol degradation. Furthermore, the electron-deficient nitrogen atoms in O-Ti-N nitrides could also account for the higher activity since it could inhibit the recombination between the photoinduced electrons and holes by capturing the photoinduced electrons. The activity of the TiO2N(SC) first increased and then decreased with the increase of the N-content. The TiO2N(SC)-1 with N/Ti molar ratio of 1.73% exhibited maximum activity, which was even much higher than P-25.
 ...
PMID:Highly active TiO2N photocatalysts prepared by treating TiO2 precursors in NH3/ethanol fluid under supercritical conditions. 1647 15

Nitrogen doping-induced changes in the electronic properties, defect formation, and surface structure of TiO2 rutile(110) and anatase(101) single crystals were investigated. No band gap narrowing is observed, but N doping induces localized N 2p states within the band gap just above the valence band. N is present in a N(III) valence state, which facilitates the formation of oxygen vacancies and Ti 3d band gap states at elevated temperatures. The increased O vacancy formation triggers the 1 x 2 reconstruction of the rutile (110) surface. This thermal instability may degrade the catalyst during applications.
 ...
PMID:Influence of nitrogen doping on the defect formation and surface properties of TiO2 rutile and anatase. 1648 2

This study was undertaken to examine the photocatalytic degradation of explosives hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) and octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX) with a circular photocatalytic reactor, using a UV lamp as a light source and TiO2 as a photocatalyst. The effects of various parameters, such as the RDX or HMX concentration, the amount of TiO, and the initial pH, on the photocatalytic degradation rates of explosives were examined. In the presence of both UV light and TiO2 RDX and HMX were more effectively degraded than with either UV or TiO2 alone. The degradation rates were found to obey pseudo-first-order kinetics represented by the Langmuir-Hinshelwood model. Increases in the RDX and HMX degradation rates were obtained with decreasing initial concentrations of the explosives. The RDX and HMX degradation rates were higher at pH 7 than at either pH 3 or pH 11. A dose of approximately 0.7 g l(-1) of TiO2 degraded HMX more rapidly than did higher or lower TiO2 doses. RDX (20 mg l(-1)) photocatalysis resulted in an approximately 20% decrease in TOC, and HMX (5 mg l(-1)) photocatalysis resulted in a 60%, decrease in TOC within 150 minutes. A trace amount of formate was produced as an intermediate that was further mineralized by RDX or HMX photocatalysis. The nitrogen byproducts from the photocatalysis of RDX and HMX were mainly NO3- with NO2-, and NH4+. The total nitrogen recovery was about 60% from RDX (20 mg l(-1)), and 70% from HMX (5 mg l(-1)), respectively. Finally, a mechanism for RDX/HMX photocatalysis was proposed, along with supporting qualitative and quantitative evidence.
 ...
PMID:Degradation kinetics and mechanism of RDX and HMX in TiO2 photocatalysis. 1650 18

Visible-light-driven TiO2 photocatalysts doped with nitrogen have been prepared as powders and thin films in a cylindrical tubular furnace under a stream of ammonia gas. The photocatalysts thus obtained were found to have a band-gap energy of 2.95 eV. Electron spin resonance (ESR) under irradiation with visible light (lambda > or = 430 nm) afforded the increase in intensity in the visible-light region. The concentration of trapped holes was about fourfold higher than that of trapped electrons. Nitrogen-doped TiO2 has been used to investigate mechanistically the photocatalytic oxidation of trichloroethylene (TCE) under irradiation with visible light (lambda > or = 420 nm). Cl and O radicals, which contribute significantly to the generation of dichloroacetyl chloride (DCAC) in the photocatalytic oxidation of TCE under UV irradiation, were found to be deactivated under irradiation with visible light. As the main by-product, only phosgene was detected in the photocatalytic oxidation of TCE under irradiation with visible light. Thus, the reaction mechanism of TCE photooxidation under irradiation with visible light clearly differs markedly from that under UV irradiation. Based on the results of the present study, we propose a new reaction mechanism and adsorbed species for the photocatalytic oxidation of TCE under irradiation with visible light. The energy band for TiO2 by doping with nitrogen may involve an isolated band above the valence band.
 ...
PMID:Mechanistic studies of the photocatalytic oxidation of trichloroethylene with visible-light-driven N-doped TiO2 photocatalysts. 1654 17

This study investigates photocatalytic degradation of nitrogen oxides overtitania-based photocatalysts illuminated by ultraviolet and visible light. The TiO2 photocatalyst was synthesized in a sol-gel process using titanium butoxide as the precursor. After calcination between 150 and 300 degrees C, the synthesized TiO2 responded strongly to visible light photocatalytically degrading NO(x), probably because of the existence of carbonaceous species that act as sensitizers. The optimum calcination temperature was found to be around 200 degrees C. Additionally, platinum ion-doped TiO2 was prepared by impregnation using Pt(NH3)4(NO3)2 as a dopant, which improved the photocatalytic activity that degraded NO(x) in the visible light region. The Pt ion was doped in oxide form at the surface of TiO2 and was expected to be responsible for sensitization. At an optimum calcination temperature of around 200 degrees C, the Pt ion-doped TiO2 exhibited higher activity in the further oxidation of NO2 to NO3- clearly reducing NO2 selectivity. The TiO2 catalysts chemically prepared by either the sol-gel process or impregnation exhibited stronger activity than conventional TiO2 when illuminated under a fluorescent lamp. Rinsing with water was responsible for the restored reactivity of prepared TiO2 catalysts for NO(x) degradation.
 ...
PMID:Photocatalytic activity for degradation of nitrogen oxides over visible light responsive titania-based photocatalysts. 1656 78

Supported nanocrystalline titanium dioxide (TiO2) has been prepared by a post-synthesis step via Ti-alkoxide hydrolysis through the use of mesoporous SBA-15 silica. TiO2/SBA-15 composites with various TiO2 loading have been prepared and characterized by X-ray diffraction, nitrogen adsorption, Fourier transform infrared spectroscopy and diffusive reflective UV-vis spectroscopy. The addition of mesoporous SBA-15 prevents the anatase to rutile phase transformation and the growth of crystal grain. TiO2 did not block the SBA-15 pores, and their surface was fully accessible for nitrogen adsorption. Calcination in air of the composites up to 800 degrees C did not change the nanocrystal phase and slightly increased the domain size from 5.0 to 7.5 nm, indicating that the anatase TiO2 grains in the mesostructures have a relatively high thermal stability and proper pore diameter allows controlling the size of obtained titania particles. The TiO2/SBA-15 composites prepared by this study showed much higher photodegradation ability for methylene blue (MB) than commercial pure TiO2 nanoparticles P-25. Experimental results indicate that the photocatalytic activity of titania/silica mixed materials depends on the adsorption ability of composite and the photocatalytic activity of the titania, and there is an optimal ratio of Ti:Si, too high or low Ti:Si ratio will lower the photodegradation ability of the composites.
 ...
PMID:Synthesis of nano titania particles embedded in mesoporous SBA-15: characterization and photocatalytic activity. 1662 Dec 69

Plasma oxidation of benzene (C(6)H(6)) in oxygen and nitrogen was investigated using a dielectric barrier discharge (DBD) reactor with or without MnO2 or TiO2 at atmospheric pressure and without external heating except plasma heating. An alternative current power supply was used to generate corona discharges for the plasma oxidation. The energy density was controlled under 200 J/L to keep an increase in gas temperature less than 167 K. C(6)H(6) was oxidized to carbon monoxide (CO) and dioxide (CO(2)). Typically, the energy efficiency at an energy density of 92J/L was about 0.052, 0.039, and 0.024 mol/kWh with MnO2, TiO2, and without MnO2 and TiO2, respectively. Benzene oxidation mechanism was mentioned. A comparison on energy efficiency as a function of initial concentration of hydrocarbons, inorganic sulphur compounds, and chloro (fluoro and bromo) carbons was given.
 ...
PMID:Catalytic oxidation of benzene using DBD corona discharges. 1662 Dec 76

Mesoporous nanocrystalline TiO2-xNx and TiO2-xNx/ZrO2 visible-light photocatalysts have been prepared by a sol-gel method. The photocatalysts were characterized by XRD, N2 adsorption-desorption, TEM, XPS, UV/Vis, and IR spectroscopy. The photocatalytic activity of the samples was evaluated by the decomposition of ethylene in air under visible light (lambda > 450 nm) illumination. Results revealed that nitrogen was doped into the lattice of TiO2 by the thermal treatment of NH3-adsorbed TiO2 hydrous gels, converting the TiO2 into a visible-light responsive catalyst. The introduction of ZrO2 into TiO2-xNx considerably inhibits the undesirable crystal growth during calcination. Consequently, the ZrO2-modified TiO2-xNx displays higher porosity, higher specific surface area, and an improved thermal stability over the corresponding unmodified TiO2-xNx samples.
 ...
PMID:ZrO2-modified mesoporous nanocrystalline TiO2-xNx as efficient visible light photocatalysts. 1664 76


<< Previous 1 2 3 4 5 6 7 8 9 10 Next >>