Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: KEGG:D01931 (TiO2)
 11,320 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The work investigated the treatment of the concentrate produced from the reverse osmosis treatment of an MBR effluent. Two conventional chemical processes, coagulation and activated carbon adsorption, and three advanced oxidation processes (electrochemical treatment, photocatalysis and sonolysis) were applied. Coagulation with alum gave dissolved organic carbon (DOC) removals up to 42%, while FeCl(3) achieved higher removals (52%) at lower molar doses. Adsorption with granular activated carbon showed the highest DOC removals up to 91.3% for 5 g/L. The adsorption isotherm was linear with a non-adsorbable organic fraction of around 1.2 mg/L DOC. The three oxidation methods employed, electrolytic oxidation over a boron-doped diamond electrode, UVA/TiO2 photocatalysis and sonolysis at 80 kHz, showed similar behavior: during the first few minutes of treatment there was a moderate removal of DOC followed by further oxidation at a very slow rate. Electrolytic oxidation was capable of removing up to 36% at 17.8A after 30 min of treatment, sonolysis removed up to 34% at 135W after 60 min, while photocatalysis was capable of removing up to 50% at 60 min.
 ...
PMID:Advanced treatment of the reverse osmosis concentrate produced during reclamation of municipal wastewater. 1882 26

The closure of water circuits within pulp and paper mills has resulted in a higher contamination load of the final mill effluent, which must consequently be further treated in many cases to meet the standards imposed by the legislation in force. Different treatment strategies based on advanced oxidation processes (ozonation and TiO2-photocatalysis), and their combination with biological treatment (MBR), are herein assessed for effluents of a recycled paper mill and a kraft pulp mill. Ozone treatment achieved the highest efficiency of all. The consumption of 2.4 g O3 L(-1) resulted in about a 60% COD reduction treating the effluent from the kraft pulp mill at an initial pH=7; although it only reached about a 35% COD removal for the effluent of the recycled paper mill. Otherwise, photocatalysis achieved about a 20-30% reduction of the COD for both type of effluents. In addition, the effluent from the recycled paper mill showed a higher biodegradability, so combinations of these AOPs with biological treatment were tested. As a result, photocatalysis did not report any significant COD reduction improvement whether being performed as pre- or post-treatment of the biological process; whereas the use of ozonation as post-biological treatment enhanced COD removal a further 10%, summing up a total 90% reduction of the COD for the combined treatment, as well as it also supposed an increase of the presence of volatile fatty acids, which might ultimately enable the resultant wastewater to be recirculated back to further biological treatment.
 ...
PMID:Assessing the application of advanced oxidation processes, and their combination with biological treatment, to effluents from pulp and paper industry. 2407 69

Effects of the suspended titanium dioxide nanoparticles (TiO2 NPs, 50 mg/L) on the cake layer formation in a submerged MBR were systematically investigated. With nanometer sizes, TiO2 NPs were found to aggravate membrane pore blocking but postpone cake layer fouling. TiO2 NPs showed obvious effects on the structure and the distribution of the organic and the inorganic compounds in cake layer. Concentrations of fatty acids and cholesterol in the cake layer increased due to the acute response of bacteria to the toxicity of TiO2 NPs. Line-analysis and dot map of energy-dispersive X-ray were also carried out. Since TiO2 NPs inhibited the interactions between the inorganic and the organic compounds, the inorganic compounds (especially SiO2) were prevented from depositing onto the membrane surface. Thus, the postponed cake layer fouling was due to the changing features of the complexes on the membrane surface caused by TiO2 NPs.
 ...
PMID:Effects of suspended titanium dioxide nanoparticles on cake layer formation in submerged membrane bioreactor. 2428 50