Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: HUMANGGP:003721 (Poly)
 11,742 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Experiments reported here were performed to understand the mechanism by which THF increases the immunocompetence of spleen cells from NTx mice. Dibutyryl cAMP or substances which increase intracellular levels of cAMP in lymphocytes such as Poly(A:U), theophylline, or PGE(2) were shown to mimic the effect of THF and confer reactivity in an in vitro GvH response to spleen cells from NTx mice. Flufenamic acid, an antagonist to PGE(2), was shown to inhibit the induction of competence by this substance. It was found that THF induces competence by activating membranal adenyl cyclase which leads to a rise in intracellular cAMP in thymus-derived cells only. These biochemical changes occur before antigenic stimulation and are unrelated to antigenic challenge. These findings indicate that THF exerts its effect via cAMP and are in agreement with the concepts which permit to classify THF as a thymus hormone.
 ...
PMID:Hormone-like activity of a thymus humoral factor on the induction of immune competence in lymphoid cells. 414 48

The in vivo biocompatibility and biodegradation of cross-linked (co)polyethers with and without tertiary hydrogen atoms in the main chain and differing in hydrophilicity were studied by means of subcutaneous implantation in rats. After 4 days, 1 month, and 3 months postimplantation, the tissue reactions and interactions were evaluated by light microscopy (LM) and transmission electron microscopy (TEM). Poly(tetrahydrofuran) (poly(THF)), poly(propylene oxide) (poly(POx)), and poly(tetrahydrofuran-co-oxetane) (poly-(THF-co-OX)) were tested as relatively hydrophobic polyethers, and poly(ethylene oxide) (PEO) and a poly(THF)/ PEO blend were used as more hydrophilic materials. In general, all polyethers showed good biocompatibility with respect to tissue reactions and interactions, with low neutrophil and macrophage infiltration, a quiet giant cell reaction, and formation of a thin fibrous capsule. For the relatively hydrophobic polyethers studied, the biostability increased in the order poly(POx) < poly(THF-co-OX) < poly(THF), probably indicating that the absence of tertiary hydrogen atoms has a positive effect on the biostability. Concerning the more hydrophilic materials, crosslinked PEO showed the highest rate of degradation, probably due to the mechanical weakness of the hydrogel in combination with the highest presence of giant cells as a result of the high porosity. A frayed surface morphology was observed after implantation of the crosslinked poly(THF)/PEO blend, which might be due to preferential degradation of PEO domains.
 ...
PMID:In vivo testing of crosslinked polyethers. I. Tissue reactions and biodegradation. 889 35

We examine the use of thionylphosphazene-based block copolymers as matrixes for oxygen sensor applications. Poly(aminothionylphosphazene)-b-poly(tetrahydrofuran) (PATPy-PTHFx) block copolymers were prepared via reaction of ring-opened poly(chlorothionylphosphazene) with THF and subsequently with excess n-butylamine (to form PBATPy-PTHFx) or methylamine (to form PMATPy-PTHFx). The block copolymers were characterized by NMR, gel permeation chromatography, and differential scanning calorimetry. Films of PBATPy-PTHFx block copolymers containing platinum octaethylporphyrin or [Ru(dpp)3]Cl2 (dpp = 4,7-diphenyl-1,10-phenanthroline) as the oxygen-sensitive chromophore were prepared, and time-scan experiments were carried out to determine the diffusion coefficients, Do2, and solubilities, So2, of oxygen therein. Despite microphase separation, the data fit well to a simple Fick's law description of oxygen diffusion and gave Do2 values smaller than that for the n-butylamino-substituted PBATP635. For films freshly annealed above the melting point of PTHFx, the Do2 values were 35-50% (dye-dependent) larger than after aging 3 days at room temperature. Films with [Ru(dpp)3]Cl2 as the dye were evaluated as media for phosphorescent pressure-sensing. The dye-containing polymer films exhibit linear Stern-Volmer-like plots, even at high dye concentrations, as well as good photostability, and significantly higher sensitivity to oxygen quenching than simple mixtures of the analogous homopolymers.
 ...
PMID:Phosphorescent oxygen sensors utilizing sulfur-nitrogen-phosphorous polymer matrixes: synthesis, characterization, and evaluation of poly(thionylphosphazene)-b-poly(tetrahydrofuran) block copolymers 1078 59

Poly(N-isopropylacrylamide-co-3-trimethoxysilylpropyl methacrylate) was prepared by radical polymerization and was grafted onto the surface of spherical colloidal silica. The copolymer, which had on average 1 silyl group per chain, condensed on the silica dispersed in THF at 60 degrees C. The resulting particles had a critical coagulation concentration of calcium chloride of 500 mM at room temperature, indicating robust colloidal stability. By contrast, heating the suspension to 50 degrees C lowered the critical coagulation concentration by more than three orders of magnitude, giving a value of 0.1 mM. Thus, the PNIPAM shell induced temperature-sensitive colloidal stability in the silica dispersion. The coated silica particles were also surface active. However, the surface tension of 50 mJ/m(2) at 25 degrees C is 15% higher than the corresponding value for PNIPAM solutions. Copyright 2000 Academic Press.
 ...
PMID:Properties of Poly(N-isopropylacrylamide)-Grafted Colloidal Silica. 1087 27

Novel switchable chiroptical characteristics of poly(alkylarylsilane) microaggregates, controllable by the choice of good/poor solvent ratio (solvent polarity), solvent addition order, and sample temperature are described. The formation of stable chiral aggregates depends critically on the polysilane structure and stereochemistry. Poly[n-hexyl-(p-(S)-2-methylbutoxyphenyl)silane] (1), optically inactive in molecularly dispersed THF solution due to the existence of dynamically equivalent amounts of right (P)- and left (M)-handed screw sense helical main chain domains, shows a marked bisignate CD signal due to the formation of chiral aggregates in good/poor cosolvent systems. The sign and magnitude of the CD signals are dependent on solvent polarity, solvent addition order, and thermal effects. The less sterically hindered poly[methyl-(p-(S)-2-methylbutoxyphenyl)silane] (2) exhibits a weak, bisignate, nonswitchable CD signal in only the toluene/acetonitrile system, and no CD signals are evident in pure toluene or THF due to masking of the helicity. In contrast, although the even less sterically hindered, less polar poly[methyl-(m-(S)-2-methylbutoxyphenyl)silane] (3) does show optical activity in pure THF or toluene (negative CD signal at 310 nm), the CD signal disappears on formation of aggregates in good/poor cosolvent systems.
 ...
PMID:Solvent and temperature effects on the chiral aggregation of poly(alkylarylsilane)s bearing remote chiral groups. 1145 17

Poly(epsilon-caprolactone)/poly(ethylene glycol) (abbreviated as CE) diblock copolymers were synthesized to make core-shell type nanoparticles for all-trans-retinoic acid (atRA). Fluorescence spectroscopy showed that critical association concentration (CAC) value decreased at higher MW of CE diblock copolymer. Drug loading characteristics were studied under various experimental conditions. Drug contents and loading efficiency increased as the MW of poly(epsilon-caprolactone) (PCL) block of CE and initial drug feeding amount increased. Solvent used and preparation method also affected drug contents and loading efficiency. According to 1H NMR using CDCl3 and D2O, specific peaks of the PCL block and drug appearing in CDCl3, disappeared at D2O, suggesting hydrophobic core with hydrophilic shell formed in water. atRA release was faster at smaller MW of copolymer and lower drug contents. Nanoparticles prepared in DMF showed faster release rate compared with those prepared in THF or acetone. Cytotoxicity of atRA against U87MG, U251MG and U343MG cell lines were increased by nanoencapsulation while empty nanoparticles of CE diblock copolymer were not significantly affected.
 ...
PMID:All-trans-retinoic acid release from core-shell type nanoparticles of poly(epsilon-caprolactone)/poly(ethylene glycol) diblock copolymer. 1501 Jan 34

(Z)-3-[2H1]-Phenylprop-2-enone is isomerised by hydroperoxide to an equimolar mixture of the (Z)- and (E)-isomers prior to epoxidation. Poly-(L)-leucine (10 mole %) accelerates the addition of hydroperoxide by an order of magnitude and sequesters hydroperoxide from THF.
 ...
PMID:The isomerisation of (Z)-3-[2H1]-phenylprop-2-enone as a measure of the rate of hydroperoxide addition in Weitz-Scheffer and Julia-Colonna epoxidations. 1536 53

Sol-gel polytetrahydrofuran (poly-THF) coating was developed for high-sensitivity sample preconcentration by capillary microextraction (CME). Parts per quadrillion (ppq) level detection limits were achieved for both polar and nonpolar analytes through sample preconcentration on sol-gel poly-THF coated microextraction capillaries followed by gas chromatography (GC) analysis of the extracted compounds using a flame ionization detector (FID). The sol-gel coating was in situ created on the inner walls of a fused silica capillary using a sol solution containing poly-THF as an organic component, methyltrimethoxysilane (MTMOS) as a sol-gel precursor, trifluoroacetic acid (TFA, 5% water) as a sol-gel catalyst, and hexamethyldisilazane (HMDS) as a deactivating reagent. The sol solution was introduced into a hydrothermally-treated fused silica capillary and the sol-gel reactions were allowed to take place inside the capillary for 60 min. A wall-bonded coating was formed due to the condensation of silanol groups residing on the capillary inner surface with those on the sol-gel network fragments evolving in close vicinity of the capillary walls. Poly-THF is a medium polarity polymer, and was found to be effective in carrying out simultaneous extraction of both polar and nonpolar analytes. Efficient extraction of a wide range of trace analytes from aqueous samples was accomplished using sol-gel poly-THF coated fused silica capillaries for further analysis by GC. The test analytes included polycyclic aromatic hydrocarbons (PAHs), aldehydes, ketones, chlorophenols, and alcohols. To our knowledge, this is the first report on the use of a poly-THF based sol-gel material in analytical microextraction. Sol-gel poly-THF coated CME capillaries showed excellent solvent and thermal stability (>320 degrees C).
 ...
PMID:Parts per quadrillion level ultra-trace determination of polar and nonpolar compounds via solvent-free capillary microextraction on surface-bonded sol-gel polytetrahydrofuran coating and gas chromatography-flame ionization detection. 1548 55

Poly(anilineboronic acid) thin films are treated under various conditions to achieve substitution or condensation reactions involving the boronic acid moiety. These reactions are studied with polarization modulated infrared reflection absorption spectroscopy, cyclic voltammetry, and UV-vis spectroscopy. The results suggest the single-step formation of substituted polyanilines, such as poly(hydroxyaniline), halogenated polyanilines, and mercury chloride-substituted polyaniline. A condensation reaction of poly(anilineboronic acid) with cis-diol compounds in aqueous solution, as well as with phenylenebisboronic acid and salycilamide in THF, indicates the formation of boronic esters. The latter reactions appear to be a good entry point for the formation of complex or supramolecular polymer structures.
 ...
PMID:Substitution and condensation reactions with poly(anilineboronic acid): reactivity and characterization of thin films. 1580 19

Poly(methyl acrylate)-grafted poly(methyl-n-propylsilane) (PMPrS-g-PMA) and poly(acrylic acid)-grafted PMPrS (PMPrS-g-PAA) were synthesized by gamma-ray-induced graft polymerization, and the association behavior of these graft copolymers was investigated in selective solvents composed of good and poor solvents for the PMPrS main chain. Fluorescence spectroscopy with perylene as a fluorescent probe revealed that PMPrS-g-PAA in a water/THF mixed solvent self-assembles into micelles with a swollen core of PMPrS chains in the water content range of 50-95%. UV spectroscopy demonstrated that a further increase of the water content gives rise to the conformational transition of the PMPrS chains in the micelle core from the random conformation to the conformation that corresponds to that in the solid state at a water content of ca. 95%, independent of the grafting yield. Similar behavior was also observed in DMSO/THF solutions of PMPrS-g-PMA, for which the conformational transition occurred at the constant DMSO content of ca. 95%. These results indicate that solvatochromic behavior of polysilane, which is a characteristic feature of polysilane, proved to provide information on the inner structure of those micelles: PMPrS chains in the core undergo conformational transition as the content of the poor solvents for PMPrS increases, while maintaining the micelle structure.
 ...
PMID:Conformational transition of the core chain in radiation-modified polysilane micelles formed in selective solvents. 1608 71


1 2 3 4 Next >>