Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: EC:4.1.2.42 (DTA)
 1,693 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Morphological, structural, adsorption, and catalytic properties of highly disperse titania prepared using sulfate and pyrogenic methods, and fumed titania-containing mixed oxides, were studied using XRD, TG/DTA, nitrogen adsorption, (1)H NMR, FTIR, microcalorimetry on immersion of oxides in water and decane, thermally stimulated depolarization current (TSDC) and catalytic photodecomposition of methylene blue (MB). Phase composition and aggregation characteristics of nanoparticles (pore size distribution) of sulfate and pyrogenically prepared titania are very different; temperature dependent structural properties are thus very different. Catalytic activity for the photodecomposition of MB is greatest (per gram of TiO(2) for the pure oxide materials) for non-treated ultrafine titania PC-500, which has the largest S(BET) value and smallest particle size of the materials studied. However, this activity calculated per m(2) is higher for PC-105, possessing a much smaller S(BET) value than PC-500. The activity per unit surface area of titania is greatest for the fumed silica-titania mixed oxide ST20. Calcination of PC-500 at 650 degrees C leads to enhancement of anatase content and catalytic activity, but heating at 800 and 900 degrees C lowers the anatase content (since rutile appears) and diminishes catalytic activity, as well as the specific surface area because of nanoparticle sintering.
 ...
PMID:Structural and adsorption characteristics and catalytic activity of titania and titania-containing nanomaterials. 1899 39

(Solid + liquid) phase equilibria (SLE) for the binary systems, ionic liquid (IL) 1-butyl-3-methylimidazolium thiocyanate [BMIM][SCN] with an alcohol (1-octanol, 1-nonanol, 1-decanol, 1-undecanol, or 1-dodecanol) or water, and (liquid + liquid) phase equilibria (LLE) for the binary systems of [BMIM][SCN] with an alkane (n-hexane, n-heptane, n-octane, n-nonane, or n-decane), benzene, an alkylbenzenes (toluene or ethylbenzene), tetrahydrofuran (THF), cycloalkanes (cyclohexane or cycloheptane), or ethers (di-n-propyl ether, di-n-butyl ether, di-n-pentyl ether, n-butylmethyl ether, tert-butylmethyl ether (MTBE), or tert-butylethyl ether (ETBE)) have been determined at ambient pressure. A dynamic method was used over a broad range of mole fractions and temperatures from 250 to 430 K. In the case of systems IL + alkane, cycloalkane, or ether, the mutual immiscibility with an upper critical solution temperature (UCST) was detected, and in the systems of IL + benzene, alkylbenzene, or THF, the mutual immiscibility with a lower critical solution temperature (LCST) was observed. UV-vis spectroscopy was used to determine the very small compositions of the IL in the n-hexane (about 2 x 10(-5) IL mole fraction), benzene (about 2 x 10(-3) IL mole fraction), cyclohexane (about 2 x 10(-5) IL mole fraction), and THF (about 1.2 x 10(-2) IL mole fraction). For the binary systems containing alcohol, it was noticed that with increasing chain length of an alcohol, the solubility decreases. The basic thermal properties of the pure IL, that is, the glass-transition temperature as well as the heat capacity at the glass-transition temperature, have been measured using a differential scanning microcalorimetry technique (DSC). Decomposition of the IL was detected by the simultaneous TG/DTA experiments. Well-known UNIQUAC, Wilson, and NRTL equations have been used to correlate the experimental SLE data sets for alcohols and water. For the systems containing immiscibility gaps {IL + alkane, benzene, alkylbenzene, cycloalkane, tetrahydrofuran, or ether}, the parameters of the LLE correlation have been derived using the NRTL equation.
 ...
PMID:Phase equilibria study of the binary systems (1-butyl-3-methylimidazolium thiocyanate ionic liquid + organic solvent or water). 1940 27