Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: EC:3.4.25.1 (proteasome)
 28,817 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

We have used cDNA encoding D-amino acid oxidase, and genomic DNA encoding cephalosporin acylase from Fusarium solani and Pseudomonas diminuta, respectively, to construct a novel hybrid 7-aminocephalosporanic acid (7ACA) biosynthetic operon under the control of regulatory elements from the alkaline protease gene of Acremonium chrysogenum. Transformants of A. chrysogenum BC2116, a high cephalosporin-producing strain, containing this operon, synthesized and secreted low levels of 7ACA. Although the amounts are not yet commercially significant, this represents the first microbial production of 7ACA and demonstrates the feasibility of introducing new biosynthetic capabilities into industrial microorganisms by combining fungal and bacterial genes.
 ...
PMID:Construction of a 7-aminocephalosporanic acid (7ACA) biosynthetic operon and direct production of 7ACA in Acremonium chrysogenum. 136 53

Post-exposure annealing of highly sensitive LiF:Mg,Cu,P (MCP-N) detectors, at 100 degrees C over 10 or 20 min prior to readout, is usually recommended for routine dosimetry. The purpose of this anneal is to eliminate low-temperature peaks, especially peak 3, which fades at room temperature in about 3 months. However, as this annealing procedure does not entirely eliminate peak 3, 10% of its thermoluminescent (TL) signal still being readable, a fading correction must be applied. The aim of this work was to optimise the conditions of post-exposure treatment, i.e. its temperature and duration, in order to facilitate the use of MCP-N detectors in routine dosimetry. MCP-N detectors were annealed in standard conditions, i.e. at 240 degrees C over 10 min and exposed to a dose of 5 mGy (137Cs). For post-exposure annealing, six different temperatures between 100 degrees C and 150 degrees C and two time periods (10 and 20 min) were tested. TL glow curves were deconvoluted with the GCA code. A post-exposure anneal at 120 degrees C over 10 min was found to be optimal. Heating at this temperature eliminates 100% of the TL signal of peak 3, while maintaining the area and maximum intensity of the main peak 4 unchanged. In this case, no fading correction needs to be applied. Annealing at higher temperatures, up to 150 degrees C, results in a loss of peak 4 signal, and is therefore not recommended.
 ...
PMID:The influence of post-exposure heating on the stability of MCP-N (LiF:Mg,Cu,P) TL detectors. 1238 47