Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: EC:1.12.7.2 (hydrogenase)
 3,522 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

The method of solution and puridication of hydrogenase from chromatophores of purpur sulphur bacteria Thiocapsa roseopersicina strain BBS are described. Hydrogenase molecular weight is 73000. It contains 4,4 mole S2- and 3.1 mole Fe2+ per mole of protein; pI 4.15. The enzyme absorption spectrum has the maximun et 400-410 nm, which is characteristic of proteins containing non-haem iron. Membrane--linked enzyme as well as soluble hydrogenase of that microorganism is characterized by high thermal stability: inactivation occurs at the temperature above 78 degrees C when the optimal temperature for that enzyme is 70 degrees C. Homogenous enzyme catalyses D2--H2O exchange reaction, reversible redox reaction of methyl viologene and benzyl viologene.
 ...
PMID:[Purification and properties of phototrophic bacteria Thiocapsa roseopersicina hydrogenase bound with chromatophores]. 1 62

The isolation method and some peoperties of purple sulphur bacteria (Thiocapsa roseopersicina strain BBS) hydrogenase are described Hydrogenase molecular weight is found to be 66000; it contains 3.7 moles of S2- and 3.9 moles of Fe2+ per one mole of the enzyme;pI=4.2. The enzyme absorption spectrum has the maximum at 400-412 nm which is characteristic of proteins containing non-haem iron. Hydrogenase is suggested to consist pf 4 subunits of two types: with molar weight 27000 and 6000. Unlike other hydrogenases, this enzyme is rather resistant to O2 and is more thermostable: the inactivation of the enzyme was observed at the temperature above 80 degrees C; Hydrogenase preparation catalyses D2-H2O exchange reaction, H2 evolution from the reduced methyl viologene (MV) and H2 absorption in the presense of MV or benzylviologene but not in the presense of NAD(P), FAD, FMN, azocarmine, methylene blue and ferricyanide.
 ...
PMID:[Purification and properties of hydrogenase from phototrophic bacterium Thiocapsa roseopersicina]. 102 87

A soluble [NiFe] hydrogenase has been partially purified from the obligate thermophilic sulfate-reducing bacterium Thermodesulfobacterium mobile. A 17% purification yield was obtained after four chromatographic steps and the hydrogenase presents a purity index (A398 nm/A277 nm) equal to 0.21. This protein appears to be 75% pure on SDS-gel electrophoresis showing two major bands of molecular mass around 55 and 15 kDa. This hydrogenase contains 0.6-0.7 nickel atom and 7-8 iron atoms per mole of enzyme and has a specific activity of 783 in the hydrogen uptake reaction, of 231 in the hydrogen production assay and of 84 in the deuterium-proton exchange reaction. The H2/HD ratio is lower than one in the D2-H+ exchange reaction. The enzyme is very sensitive to NO, relatively little inhibited by CO but unaffected by NO2-. The EPR spectrum of the native hydrogenase shows the presence of a [3Fe-4S] oxidized cluster and of a Ni(III) species.
 ...
PMID:Partial purification and characterization of the first hydrogenase isolated from a thermophilic sulfate-reducing bacterium. 131 68

The formate-hydrogen lyase complex of Escherichia coli decomposes formic acid to hydrogen and carbon dioxide under anaerobic conditions in the absence of exogenous electron acceptors. The complex consists of two separable enzymatic activities: a formate dehydrogenase and a hydrogenase. The formate dehydrogenase component (FDHH) of the formate-hydrogen lyase complex was purified to near homogeneity in two column chromatographic steps. The purified enzyme was composed of a single polypeptide of molecular weight 80,000 as determined by sodium dodecyl sulfate-polyacrylamide gel electrophoresis. Metal analysis showed each mole of enzyme contained 3.3 g atoms of iron. Denaturation of FDHH released a compound which, when oxidized, displayed a fluorescence spectrum similar to that of the molybdopterin cofactor found in certain other enzymes. The enzyme contained selenium in the form of selenocysteine as determined by radioactive labeling of the enzyme with 75Se and amino acid analysis. FDHH activity was maximal between pH 7.5 and 8.5; however, the enzyme was maximally stable at pH 5.3-6.4 and highly unstable above pH 7.5. Nitrate and nitrite salts caused a drastic reduction in activity. Although azide inhibited FDHH activity, it also protected the enzyme from inactivation by oxygen.
 ...
PMID:Escherichia coli formate-hydrogen lyase. Purification and properties of the selenium-dependent formate dehydrogenase component. 221 98

A brown carbon monoxide dehydrogenase from CO-autotrophically grown cells of Acinetobacter sp. strain JC1, which is unstable outside the cells, was purified 80-fold in seven steps to better than 95% homogeneity, with a yield of 44% in the presence of the stabilizing agents iodoacetamide (1 mM) and ammonium sulfate (100 mM). The final specific activity was 474 mumol of acceptor reduced per min per mg of protein as determined by an assay based on the CO-dependent reduction of thionin. Methyl viologen, NAD(P), flavin mononucleotide, flavin adenine dinucleotide, and ferricyanide were not reduced by the enzyme, but methylene blue, thionin, and dichlorophenolindophenol were reduced. The molecular weight of the native enzyme was determined to be 380,000. Sodium dodecyl sulfate-gel electrophoresis revealed at least three nonidentical subunits of molecular weights 16,000 (alpha), 34,000 (beta), and 85,000 (gamma). The purified enzyme contained particulate hydrogenase-like activity. Selenium did not stimulate carbon monoxide dehydrogenase activity. The isoelectic point of the native enzyme was found to be 5.8; the Km of CO was 150 microM. The enzyme was rapidly inactivated by methanol. One mole of native enzyme was found to contain 2 mol of each of flavin adenine dinucleotide and molybdenum and 8 mol each of nonheme iron and labile sulfide, which indicated that the enzyme was a molybdenum-containing iron-sulfur flavoprotein. The ratio of densities of each subunit after electrophoresis (alpha:beta:gamma = 1:2:6) and the number of each cofactor in the native enzyme suggest a alpha 2 beta 2 gamma 2 structure of the enzyme. The carbon monoxide dehydrogenase of Acinetobacter sp. strain JC1 was found to have no immunological relationship with enzymes of Pseudomonas carboxydohydrogena and Pseudomonas carboxydovorans.
 ...
PMID:Purification and some properties of carbon monoxide dehydrogenase from Acinetobacter sp. strain JC1 DSM 3803. 253 87

A soluble hydrogenase from the halophilic sulfate reducing bacterium Desulfovibrio salexigens, strain British Guiana (NCIB 8403) has been purified to apparent homogeneity with a final specific activity of 760 mumoles H2 evolved/min/mg (an overall 180-fold purification with 20% recovery yield). The enzyme is composed of two non-identical subunits of molecular masses 62 and 36 kDa, respectively, and contains approximately 1 Ni, 12-15 Fe and 1 Se atoms/mole. The hydrogenase shows a visible absorption spectrum typical of an iron-sulfur containing protein (A400/A280 = 0.275) and a molar absorbance of 54 mM-1cm-1 at 400 nm. In the native state (as isolated, under aerobic conditions), the enzyme is almost EPR silent at 100 K and below. However, upon reduction under H2 atmosphere a rhombic EPR signal develops at g-values 2.22, 2.16 and around 2.0, which is optimally detected at 40 K. This EPR signal is reminiscent of the nickel signal C (g-values 2.19, 2.16 and 2.02) observed in intermediate redox states of the well characterized D. gigas nickel containing hydrogenase and assigned to nickel by 61 Ni isotopic substitution (J.J.G. Moura, M. Teixeira, I. Moura, A.V. Xavier and J. Le Gall (1984), J. Mol. Cat., 23, 305-314). Upon longer incubation with H2 the "2.22" EPR signal decreases. During the course of a redox titration under H2, this EPR signal attains a maximal intensity around--380 mV. At redox states where this "2.22" signal develops (or at lower redox potentials), low temperature studies (below 10 K) reveals the presence of other EPR species with g-values at 2.23, 2.21, 2.14 with broad components at higher fields. This new signal (fast relaxing) exhibits a different microwave power dependence from that of the "2.22" signal, which readily saturates with microwave power (slow relaxing). Also at low temperature (8 K) typical reduced iron-sulfur EPR signals are concomitantly observed with gmed approximately 1.94. The catalytic properties of the enzyme were also followed by substrate isotopic exchange D2/H+ and H2 production measurements.
 ...
PMID:Redox properties and activity studies on a nickel-containing hydrogenase isolated from a halophilic sulfate reducer Desulfovibrio salexigens. 301 50

The soluble hydrogenase of Desulfovibrio vulgaris was purified and some of its properties are described. The molecular weight was determined for the enzyme by sedimentation equilibrium (45,400) and amino acid analysis (44,800). The hydrogenase appears to be a loosely coiled molecule or to have a high axial ratio, which is reflected in an unusually low sedimentation coefficient (2.58S) and a low diffusion coefficient (D 5.85). The molecular weight of the hydrogenase (41,000), as calculated by the Svedberg equation, was in general agreement with the sedimentation equilibrium molecular weight. Amino acid analysis revealed the presence of six halfcystine residues per mole of enzyme and a total of 417 amino acid residues. The specificity of the hydrogenase and its capacity to reduce certain low potential dyes and cytochrome c(3) was studied. Metal analysis of the hydrogenase indicated the presence of 1 mole of ferrous iron per mole of enzyme.
 ...
PMID:Purification and properties of a hydrogenase from Desulfovibrio vulgaris. 554 Oct 10

The thiosulfate reductase of Desulfovibrio vulgaris has been purified and some of its properties have been determined. Only one protein component was detected when the purified enzyme was subjected to polyacrylamide gel electrophoresis at pH values of 8.9, 8.0, and 7.6. In the presence of H(2), the enzyme, when coupled to hydrogenase and with methyl viologen as an electron carrier, catalyzed the reduction of thiosulfate to hydogen sulfide. The use of specifically labeled (35)S-thiosulfate revealed that the outer sulfur atom was reduced to sulfide and the inner sulfur atom was released as sulfite. Thus, the enzyme catalyzes the reductive dismutation of thiosulfate to sulfide and sulfite. The molecular weight of the enzyme was determined by sedimentation equilibrium (16,300) and amino acid analysis (15,500). The enzyme sedimented as a single, symmetrical component with a calculated sedimentation coefficient of 2.21S. Amino acid analysis revealed the presence of two half-cystine residues per mole of enzyme and a total of 128 amino acid residues. Carbohydrate and organic phosphorus analyses revealed the presence of 9.2 moles of carbohydrate and 4.8 moles of phosphate per mole of enzyme. The substrate specificity of the enzyme was studied.
 ...
PMID:Thiosulfate reductase of Desulfovibrio vulgaris. 557 35

A hydrogenase from a new species of sulfate reducing bacterium has been isolated and characterized. In contrast to other hydrogenases isolated from Desulfovibrio, this enzyme is found in the cytoplasmic fraction rather than in the periplasm. The specific activity of the enzyme, as measured in the hydrogen evolution assay, is twice as high as the specific activity of the hydrogenase from D. gigas. It also differentiates itself from the periplasmic Desulfovibrio hydrogenases by being more active in the hydrogen evolution rather than in the hydrogen uptake assay. The enzyme was shown to contain 0.9 atoms of nickel, 11 atoms of iron and 10 atoms of labile sulfide per mole of enzyme. It exhibits an unusually low intensity of the g = 2.31 nickel EPR signal in the isolated enzyme but shows a normal intensity for the g = 2.19 nickel EPR signal when reduced under hydrogen.
 ...
PMID:A cytoplasmic nickel-iron hydrogenase with high specific activity from Desulfovibrio multispirans sp. N., a new species of sulfate reducing bacterium. 609 50

Selenium occurs normally in living things as a highly specific component of certain enzymes and amino acid transfer nucleic acids (tRNAs). In bacteria, biosynthesis of essential selenoenzymes has been shown to be unaffected by wide variations in sulfur levels. The naturally occurring selenoenzymes so far identified from bacterial sources include glycine reductase, certain formate dehydrogenases, a hydrogenase, nicotinic acid hydroxylase, xanthine dehydrogenase and thiolase. The selenoenzyme, glutathione peroxidase, and three other selenoproteins of unknown function have been isolated from animals. In certain enzymes, e.g. glycine reductase, formate dehydrogenase, hydrogenase and glutathione peroxidase, the chemical form of selenium has been identified as selenocysteine. One enzyme, a bacterial thiolase, contains selenomethionine rather than selenocysteine. A labile, unidentified form of selenium is present in nicotinic acid hydroxylase, and by inference, xanthine dehydrogenase. The seleno-tRNAs serve as examples of a different type of biological macromolecule that is specifically modified with selenium. The major seleno-tRNAs in Clostridium sticklandii and Escherichia coli have been identified as glutamate and lysine isoaccepting species. The selenium-modified nucleoside is 5-methyl-aminomethyl-2-selenouridine (mnm5Se2U), which is the chemical analog of 5-methylaminomethyl-2-thiouridine, a previously identified minor base of E. coli tRNA2Glu. The seleno-tRNAGlu of C. sticklandii contains one gram atom of Se per mole of biologically active tRNA. Loss of Se from the modified nucleoside, mnm5Se2U, in this tRNA results in concomitant loss of glutamate charging activity suggesting that selenium is essential for interaction of the synthetase and its cognate tRNA.
 ...
PMID:New biologic functions--selenium-dependent nucleic acids and proteins. 622 14


1 2 3 Next >>