Gene/Protein Disease Symptom Drug Enzyme Compound
Pivot Concepts:   Target Concepts:
Query: EC:1.10.3.2 (laccase)
4,656 document(s) hit in 31,850,051 MEDLINE articles (0.00 seconds)

Pleurotus ostreatus No. 42 produced the ligninolytic enzymes, manganese peroxidase (MnP) and laccase, in agitation culture in glucose/peptone/wheat-bran medium. Formation of mycelial pellets 1-2 mm in diameter was essential for the production of MnP; and the concentration of dissolved oxygen in the culture medium greatly influenced the production of MnP, a concentration over 5 ppm being necessary for MnP production. The maximal activity of MnP was obtained on days 7-9 of culture, after the consumption of nutrient glucose. Introduction of oxygen from the start of the cultivation caused large pellet formation, which resulted in a low MnP activity level. P. ostreatus No. 42 produced two MnP isozymes in agitation culture. The major isozyme, F-2, was 36.4 kDa and had a pI of 3.95. The MnP characteristics, Km values, dependence on Mn2+ and optimum pH showed the similarity between this isozyme and MnP 3, which was produced under different culture conditions. Analysis of the N-terminal amino acid sequence indicated the close similarity of F-2 to MnP 3.
...
PMID:Production of manganese peroxidase by pellet culture of the lignin-degrading basidiomycete, Pleurotus ostreatus. 1152 18

The white-rot fungus Coriolus hirsutus strain 075 excretes considerable amounts of laccase and Mn-peroxidase into culture broth over a brief production time. The effects of agitation speed, temperature, aeration and inoculum amount on laccase production using a 10-l fermentor were studied. The optimum fermentation conditions were a 15% inoculum, an aeration rate of 0.88 vvm, an agitation speed of 160 rpm, and a temperature of 28 degrees C. By optimizing the fermentation conditions, the laccase activity reached 80+/-3 U/ml in 3 d and the purified enzyme output was 30 mg/l. The laccase and Mn-peroxidase were purified by means of isoelectrofocusing and ion-exchange chromatography. The pIs of the laccase isoenzymes were 4.2 and 4.5. Mn-peroxidase had only one isoenzyme with a pI of 3.2. The optimum pH was 4.5 for laccase with syringaldazine as the substrate and 5.0-5.3 for Mn-peroxidase with Mn(+2) and H2O2 as the substrates. The laccase and Mn-peroxidase retained 50% of their activities at 50 degrees C after 55 h and 12 h of incubation time, respectively.
...
PMID:Laccase and Mn-peroxidase production by Coriolus hirsutus strain 075 in a jar fermentor. 1623 31

In recent years, use of microbial biomass for decolourization of textile industry wastewater is becoming a promising alternative in which some bacteria and fungi are used to replace present treatment processes. Saccharomyces cerevisiae MTCC 463 decolourized the triphenylmethane dyes (malachite green, cotton blue, methyl violet and crystal violet) by biosorption, showing different decolourization patterns. However, malachite green decolourized by biosorption at the initial stage and further biodegradation occurred, about 85% in plain distilled water within 7 h, and about 95.5% in 5% glucose medium within 4 h, under aerobic conditions and at room temperature. Decolourization of malachite green depends on various conditions, such as concentration of dye, concentration of cells, composition of medium and agitation. HPLC, UV-VIS, FTIR and TLC analysis of samples extracted with ethyl acetate from decolourized culture flasks confirmed the biodegradation of malachite green into several metabolites. A study of the enzymes responsible for the biodegradation of malachite green in the control and cells obtained after decolourization showed the activities of laccase, lignin peroxidase, NADH-DCIP reductase, malachite green reductase and aminopyrine N-demethylase in control cells. A significant increase in the activities of NADH-DCIP reductase and MG reductase was observed in the cells obtained after decolourization, indicating a major involvement of reductases in malachite green degradation.
...
PMID:Biotransformation of malachite green by Saccharomyces cerevisiae MTCC 463. 1654 73

Experimental design and response surface methodologies were applied to optimize laccase production by Trametes versicolor in a bioreactor. The effects of three factors, initial glucose concentration (0 and 9 g/L), agitation (100 and 180 rpm), and pH (3.0 and 5.0), were evaluated to identify the significant effects and its interactions in the laccase production. The pH of the medium was found to be the most important factor, followed by initial glucose concentration and the interaction of both factors. Agitation did not seem to play an important role in laccase production, nor did the interaction agitation x medium pH and agitation x initial glucose concentration. Response surface analysis showed that an initial glucose concentration of 11 g/L and pH controlled at 5.2 were the optimal conditions for laccase production by T. versicolor. Under these conditions, the predicted value for laccase activity was >10,000 U/L, which is in good agreement with the laccase activity obtained experimentally (11,403 U/L). In addition, a mathematical model for the bioprocess was developed. It is shown that it provides a good description of the experimental profile observed, and that it is capable of predicting biomass growth based on secondary process variables.
...
PMID:Optimization and modeling of laccase production by Trametes versicolor in a bioreactor using statistical experimental design. 1696 Feb 82

Response surface methodology was employed for the optimization of different nutritional and physical parameters for the production of laccase by the filamentous bacteria Streptomyces psammoticus MTCC 7334 in submerged fermentation. Initial screening of production parameters was performed using a Plackett - Burman design and the variables with statistically significant effects on laccase production were identified. Incubation temperature, incubation period, agitation rate, concentrations of yeast extract, MgSO(4)7H(2)O, and trace elements were found to influence laccase production significantly. These variables were selected for further optimization studies using a Box-Behnken design. The statistical optimization by response surface methodology resulted in a three-fold increase in the production of laccase by S. psammoticus MTCC 7334.
...
PMID:Optimization of laccase production from a novel strain-Streptomyces psammoticus using response surface methodology. 1720 81

Saccharomyces cerevisiae MTCC 463 decolourizes toxic azo dye, methyl red by degradation process. Methyl red (100mgl(-1)) is degraded completely within 16min in plain distilled water under static anoxic condition, at the room temperature. Effect of physicochemical parameters (pH of medium, composition of medium, concentration of cells, concentration of dye, temperature and agitation) on methyl red decolourization focused the optimal condition required for decolourization. Biodegradation (fate of metabolism) of methyl red in plain distilled water was found to be pH dependent. Cells of Saccharomyces cerevisiae could degrade methyl red efficiently up to 10 cycles in plain distilled water. Analysis of samples extracted with ethyl acetate from decolourized culture flasks in plain distilled water (pH 6.5) and at pH 9 using UV-VIS, TLC, HPLC and FTIR confirm biodegradation of methyl red into several different metabolites. A study of the enzymes responsible for the biodegradation of methyl red in the control and cells obtained after decolourization in plain distilled water (pH 6.5) and at pH 9 showed different levels of the activities of laccase, lignin peroxidase, NADH-DCIP reductase, azoreductase, tyrosinase and aminopyrine N-demethylase. A significant increase in the activities of lignin peroxidase and NADH-DCIP reductase was observed in the cells obtained after decolourization in plain distilled water (pH 6.5), however cells obtained at pH 9 shows increased activities of azoreductase, tyrosinase, lignin peroxidase and NADH-DCIP reductase. High efficiency to decolourize methyl red in plain distilled water and low requirement of environmental conditions enables this yeast to be used in biological treatment of industrial effluent containing azo dye, methyl red.
...
PMID:Decolourization of azo dye methyl red by Saccharomyces cerevisiae MTCC 463. 1729 52

It was found that the soil-dwelling fungus Rhizoctonia praticola 93A was capable to produce laccase in submerged cultures. Effects of culture conditions on the enzyme biosynthesis in shaken flask and aerated bioreactor cultures were evaluated to improve the yields of the process. Production of extracellular laccase was considerably intensified by the addition of Cu2+ to a carbon-limited and nitrogen-sufficient culture medium (C/N = 0.98). When an optimized medium containing glucose (2 g/l) and L-asparagine (1.5 g/l) was used and enzyme synthesis was stimulated by addition of 5 microM Cu2+ before inoculation, maximal laccase activities obtained in a batch cultivation were, approximately, 1000 nkat/l. Under these conditions, addition to the medium of the aromatic inducer 2,5-xylidine (1 mM) led to a 10-fold increase in laccase activity. Laccase productivity in shaken flask cultures was also enhanced (to more than 4000 nkat/l on day 3) by using a medium with the initial pH of 7.5. Such a high value of the optimal medium pH for laccase production by R. praticola is exceptional among the ligninolytic fungi. In fermenter fungal cultures supplemented with cupric ions, the highest laccase activity (about 4000 nkat/l after 3 days' cultivation) was reached after 24-h incubation using a bioreactor with the aeration rate of 21/min, the agitation speed of 200 rpm, and a constant medium pH of 8.0.
...
PMID:Effects of culture conditions on production of extracellular laccase by Rhizoctonia praticola. 1741 68

The process parameters influencing the production of extracellular laccases by Streptomyces psammoticus MTCC 7334 were optimized in submerged fermentation. Coffee pulp and yeast extract were the best substrate and nitrogen source respectively for laccase production by this strain. The optimization studies revealed that the laccase yield was maximum at pH 7.5 and temperature 32 degrees C. Salinity of the medium was also observed to be influencing the enzyme production. An agitation rate of 175 rpm and 15% inoculum were the other optimized conditions for maximum laccase yield (5.9 U/mL). Pyrogallol and para-anisidine proved to be the best inducers for laccase production by this strain and the enzyme yield was enhanced by 50% with these inducers. S. psammoticus was able to decolourize various industrial dyes at different rates and 80% decolourization of Remazol Brilliant Blue R (RBBR) was observed after 10 days of incubation in dye based medium.
...
PMID:Effect of inducers and process parameters on laccase production by Streptomyces psammoticus and its application in dye decolourization. 1776 39

Mushroom production on coffee pulp as substrate generates an intense black residual liquid, which requires suitable treatment. In the present study, Pleurotus ostreatus growth in wastewater from mushroom farm was evaluated as a potential biological treatment process for decolourisation as well as to obtain biomass (liquid inoculum). Culture medium components affecting mycelial growth were determined, evaluating colour removal. Laccase activity was monitored during the process. P. ostreatus was able to grow in non diluted WCP. Highest biomass yield was obtained when glucose (10 g/l) was added. The addition of this carbon source was necessary for efficient decolourisation. Agitation of the culture improved biodegradation of WCP as well as fungal biomass production. Laccase and manganese-independent peroxidase activities were detected during fungal treatment of the WCP by P. ostreatus CCEBI 3024. The laccase enzyme showed good correlation with colour loss. Both wastewater colour and pollution load (as chemical oxygen demand) decreased more than 50% after 10 days of culture. Phenols were reduced by 92%.
...
PMID:Decolourisation of mushroom farm wastewater by Pleurotus ostreatus. 1795 86

Polyporus sp. S133, a fungus collected from contaminated-soil was used to degrade chrysene, a polycyclic aromatic hydrocarbon (PAH) in a mineral salt broth (MSB) liquid culture. Maximal degradation rate of chrysene (65%) was obtained when Polyporus sp. S133 was incubated in the cultures supplemented with polypeptone (10%) for 30 days under agitation of 120 rpm, as compared to just 24% degradation rate in non-agitated culture. Furthermore, the degradation of chrysene was affected by the addition of carbon and nitrogen sources as well as kind of surfactants. The degradation rate was increased with increase in added amount of carbon and nitrogen sources, respectively. The degradation rate in agitated cultures was enhanced about 2 times higher than that in non-agitated cultures. The degradation mechanism of chrysene by Polyporus sp. S133 was determined through identification of several metabolites; chrysenequinone, 1-hydroxy-2-naphthoic acid, phthalic acid, salicylic acid, protocatechuic acid, gentisic acid, and catechol. Several enzymes (manganese peroxidase, lignin peroxidase, laccase, 1,2-dioxygenase and 2,3-dioxygenase) produced by Polyporus sp. S133 were detected during the incubation. The highest enzyme activity was shown by 1,2-dioxygenase (237.5 U l(-1)) after 20 days of incubation.
...
PMID:Biodegradation of chrysene, an aromatic hydrocarbon by Polyporus sp. S133 in liquid medium. 1883 91


1 2 3 4 Next >>